Your cart is empty.
Your cart is empty.Baseplates come in a circle or square in 4/6/ or 9" Bushings are not included Made from 1/4" plexiglass Designed and Made in America from local materials
Shawn644
Reviewed in the United States on January 11, 2025
If you are trying to use this with the inlay bushing the holse won't line up without putting pressure on the cutter.
Paul R.
Reviewed in the United States on March 14, 2024
We bought this to mount our router on the Husky job site worktable. It fits the router but the pre-drilled holes do not align with the table. That was disappointing. We will drill new holes to mount it. It is expensive for a piece of plastic and likely cheaper to make our own.
SteveF
Reviewed in the United States on January 25, 2024
This fit my Ryobi One+ 18v mini router perfectly. I bought the square one and made a little router table for it to nestle into. The plastic is 1/4" think, and though it doesn't seem to flex much, I'd feel more assured if it were a bit thicker.
Jungle
Reviewed in the United States on April 1, 2024
I do a lot of work with plastics, but I got lazy on this one. However, this saved me time and I can pay more attention to the other aspects of making a new router table. The added plus is that I can use the same screws that came with my Ryobi original tiny face-plate and the alignment is perfect.
jjv
Reviewed in the United States on September 29, 2023
I purchase both the round and square 6" bases, both are well made and accurately machined, these make a nice addition to my hand held routers. These allow for better balance of the router while doing edges. I highly recommend.
Recommended Products
