Your cart is empty.
Your cart is empty.
- General Purpose Relay S-S Stable
- 10 Amp
- 1A SPST-NO 12 VDC
- PCB terminals
Customer
Reviewed in the United States on February 26, 2025
Great price
Nylox
Reviewed in the United States on September 28, 2024
Our 3-year-old Insignia Upright Freezer just quit working one day. I saw no evidence of oil from a refrigerant leak anywhere and after some (tap tests) on the control board, I was able to get the compressor to kick on.At that point, I knew it was a control board issue and through further troubleshooting determined that one of the relays mounted on the board was the culprit. A quick desolder of the old relay and installation of this one after cutting off the unnecessary legs and we were up and running again.I did purchase a few different brands of this particular relay, but this was the 1st to arrive so I installed this one. I also like that it has a clear cover so you can see whether the contacts are burnt or pitted and verify operation.
Scrimshaw
Reviewed in the United States on August 17, 2024
These are excellent 12V relays. I tested them and compared them to the data sheet. They are very close to, or within spec on the important parameters. Here is the info:Per data sheet:260 ohm coil resistanceMust operate voltage: 9.6V @ 55mAMust release voltage: 3.6VMaximum voltage: 16.8VMy measurements:271 ohm coil resistance, 705 mH inductance.Pull in at 6.9V @ 23mADrop out at 2.75V @ 10mAAt the full 12V the holding current is 42mAI did not test the maximum voltage (to avoid testing to failure).I actually love that these pull in and drop out at fairly low voltages, and use very little current. For my use case, I feel like they exceed the spec. 5 Stars.
Nyx B.
Reviewed in the United States on November 2, 2024
All mechanical components like this should be required to be transparent :P It's really damn useful for uncovering issues.
Recommended Products
