Your cart is empty.
Your cart is empty.
For 1980 Chevrolet K10
For 1979 Chevrolet K10
For 1978 Chevrolet K10
For 1977 Chevrolet K10
For 1980 Chevrolet K20
For 1979 Chevrolet K20
For 1978 Chevrolet K20
For 1977 Chevrolet K20
For 1980 Chevrolet K5 Blazer
For 1979 Chevrolet K5 Blazer
For 1978 Chevrolet K5 Blazer
For 1977 Chevrolet K5 Blazer
For 1980 GMC Jimmy
For 1979 GMC Jimmy
For 1978 GMC Jimmy
For 1977 GMC Jimmy
For 1978 GMC K15
For 1977 GMC K15
Travlr
Reviewed in the United States on October 7, 2023
I didn't see anything wrong with this front driveshaft... except that it was too short. It's really a nice unit and I would have used it and been happy, but fully extended it was about the same length as my old shaft fully collapsed. Just not gonna work.The description says it is 29.49 inches. This must be measured from the center of the slip yoke u-joint cap to the flange surface. Most shafts are measured from the center of both outside u-joint caps so be aware that this shaft is 29.49 inches long fully collapsed and from center of cap to flange surface.
Recommended Products
