Shopping Cart

Your cart is empty.

Your cart is empty.

37110 6A440 Rear Drive Shaft Prop Shaft Driveshaft Assembly Fit for Toyota 4Runner 2003-2009 4.0L 4WD; Replace# 37110 6A440, 371106A440, 936775, 655003

5.0 Write Review
Free shipping on orders over $29.99

$116.18

$ 45 .99 $45.99

In Stock
  • 【Vehicle Fitment】Drive Shaft Fit for Toyota 4Runner 2003-2009 V6 4.0L, Rear 4WD.
  • 【DriveShaft Specifications】Installation Length (Longest)：49.02in；Installation Length (Shortest)：46.65in; Position：Rear*Please make sure your OE and length are correct before buying the driveshaft.
  • 【Excellent Performance】Drive Shaft Assembly has reached pre-balance and high temperature grease has been applied to the slip yokes & u-joints are ready to installed. Effectively reduce noise, provide you with a comfortable driving environment.
  • 【High Standard】Prop Shaft assembly made from high-quality alloy steel, ISO/ IATF 16975 certified,to meet OEM specifications, Efficiently transmit the power generated by the engine, making your car full of driving power, reduce your vehicle energy consumption.
  • 【Note】Please check year/make/model of your vehicle and check the detail information at the Product description before ordering; If you are not sure whether our parts fit your car please provide the VIN number of your car to us to confirm, We offer a wide variety of driveshafts, so there's one to match your car.


Product Description

drive shaft

Reference Number:

  • 37110-6A440, 37110 6A440, 371106A440, 936-775, 65-5003, 936775, 655003

Fits the Following Vehicles:

  • Fit for Toyota 4Runner Rear V6 4.0L 4WD 2003 2004 2005 2006 2007 2008 2009

drive shaft assembly

High-strength Steel

Drive shaft parts are made of high-strength steel with baked-on paint to prevent rust, long service life and high operating efficiency.

prop shaft

Coating Process

Superior durable coating protects shafts from premature corrosion, and new universal joints, sliding yoke, shafts and components, work well done.

automotive replacement drive shaft assemblies

OE specification

The sliding yoke and U-joints are coated with high temperature grease. The high quality coating protects the shaft from premature corrosion.

driveshaft units
3200r/min RPM
20g.cm Residual Unevenness
30g.cm Residual Unevenness of Recovery
2 pieces per end Requirement of balance piece at each end
1.2 Overall Safety Factor
≤1° Overall clearance
0.3-2N.M Universal joint starting torque
＞1.5 million time Universal joint wear test
20-120N Sliding force of sliding pair
＞150,000 times Slide wear test
<0.8mm Overall static runout
＞600,000 times Intermediate support fatigue test
＞200,000 times Torsional fatigue test
QC/T484-1999 TQ6 Standard Paint standard
Drive Shaft Prop Shaft
drive shaft assembly