Your cart is empty.
Your cart is empty.
The high-quality piezoelectric transducer ensures a purer acoustic tone for your instrument by eliminating external sound interference and is easy to install with its pre-wired harness.
Compatible with a wide range of string instruments, this durable and eco-friendly pickup is perfect for both professional musicians and enthusiasts.
Specifications:
Item: Piezo Transducer Prewired Amplifier Pick Up
Material: Metal and Piezoelectric Ceramic Sensor
Interface Diameter: 6.35mm/0.25inch
Sensor Diameter: Approx. 50mm/1.96inch
Cable Length: Approx. 50cm/20 inch
Package includes:
4 Packs x Piezo Transducer Prewired Amplifier Pick Up
Installation Instruction:
1. Remove the plastic film from the back of the transducer to reveal the adhesive.
2. Position the transducer through the sound hole to the lower front body of the guitar, where the tonal response is optimal.
3. Drill a hole from the inside of the guitar body, loosen the end-pin jack nut, insert it into the hole, and tighten the nut.
Note: The above steps may vary slightly depending on the specific instrument.
Chris From Bama
Reviewed in the United States on December 8, 2024
2 of the 4 that I ordered the solder easily broke loose from center part of the piezo. Sound quality poor- almost as if you were using a string and a can for a walkie talkie. At least I was able to salvage the pots and knobs.
Recommended Products
