Your cart is empty.
Your cart is empty.Wis PC User
Reviewed in the United States on August 19, 2024
The extension set screws stripped on the first use. When tightening the screws on the shaft of the drill, they stripped and then were useless. I can't recommend these extensions and I don't know why Amazon listed them as an Amazon choice product. I went to Home Depot and purchased a Diablo extension and it worked great. Get the Diablo that's listed on Amazon. It works.
Dave
Reviewed in the United States on February 12, 2024
Great for the price.
mark andrew Kirsch
Reviewed in the United States on February 11, 2024
I really like the design and length of the extension and the price was right
RS
Reviewed in the United States on August 17, 2023
A reasonable low cost solution for projects you need a 1/4" driver extension! The extensions are a little rough and required a little elbow grease to get the bit to seat properly in the extension.
Peter N
Reviewed in the United States on June 6, 2023
Low quality. Beware these may ruin your drill bit handle
Greg Babcock
Reviewed in the United States on June 18, 2023
The hole for the spade bit shank is too large which causes the bit the wobble much more than it should.
Vance N
Reviewed in the United States on March 20, 2023
Pros:- seems solid- depends on preference but the end has a little hex grub to lock onto the bit which is good but a little more hassle than a magnetic endCons:- as said above, have to use a hex to tighten lock screw vs just pulling bit off a magnet - good/bad I guess- the end is too thick for narrow passes. I bought this to help me gain access to narrow and deeper recessed screws but this is still too thick for half of my repairs. This is really bad for the screws that are buried inside casings with a deep well with no decent clearance. If you need something for such repairs then you are just better finding a dedicated long shank screwdriver set. This will not work.
digigill
Reviewed in the United States on April 14, 2023
The extension wobbles when used. Rolling the main shaft on a flat surface confirmed the shaft is bent. The allen screws holes are tapped crooked and this had metal shavings attached to the holes. The extension surface is raw from machining and not polished.
Recommended Products