Your cart is empty.
Your cart is empty.Product Description
-
DURABLE AND RUST-PROOF
- Durable plastic
- Anti-corrosion powder coating
- UV-resistant
-
-
The sleek design of the 4x4 post base adds stability to the post and is more modern and beautiful.
Each hole in the post is pre-drilled and has a delicate wrap-around edge.
Thicker & higher post base bottom for better structural strength on decks.
The short screws can be mounted horizontally to the posts and the long screws can be mounted vertically to the deck substrate.
Quick and easy 4x4 post anchors installation in minutes.
For maximum post height of 36".
4 x 4 POSTS
Actual inner diameter 3.5x 3.5 inches deck post base.
Used for deck posts, porches, railings, handrails, gazebos.
Can also be used as a support frame for table legs/mailbox posts.
Some post may need to be trimmed or sanded to fit.
Actual 3.5x 3.5 inches deck post base. Used for deck posts, porches, railings, handrails, gazebos. Can also be used as a support frame for table legs/mailbox posts. (May need to be modified to better fit the size you need)
Debbie
Reviewed in Canada on June 26, 2024
Very strong and durable suited our purpose quite well. Got a beautiful fence made out of the post holders
Melba Engen
Reviewed in the United States on June 11, 2024
The screws supplied are junk. The Philips. Head strips out before the screw is set all the way in.
LynnC
Reviewed in the United States on February 22, 2024
Good looking and very sturdy.
michael
Reviewed in the United States on January 5, 2024
This product was easy to use and very durable. Got the rails up to my deck in no time at all. Awesome product!
Russ Clark
Reviewed in the United States on August 30, 2023
Pleased with the post anchor s. Especially since they came with the proper screws. I didn't expect that.Thanks!!
Margaret Eckman
Reviewed in the United States on November 11, 2023
The media could not be loaded.
Hubba Bubba
Reviewed in the United States on August 26, 2022
We really like how these helped finish out our deck railing we put up. They look really good & they did add stability to the posts.I started with wide metal C brackets so I could securely anchor the posts to the framing under the composite boards. After hollowing out the bottom of the post to account for the lag bolts I used so they would sit flat, I screwed in the sides deep enough to pull the brackets in. This way these black caps would slide over the brackets.Even though the bases are attached in only a few points to real wood, they really helped add stability to the posts. I did use decking screws for most of the base & only used the supplied ones for show where they would not be screwed into anything (between decking boards). After only a few days they are rusting so it looks like I need to pull these out & replace with the decking ones I used.The shorter supplied screws are looking good so far.As these are just plastic & will fit a processed 4x4 post. (we are using pressure treated & then stained posts) Being just plastic I think they are a bit pricy, but we are happy with the end results.If you are using dimensional posts (like rough cut Cedar) that is actually 4x4", not 3.5x3.5" these will not work until you make the ends that would go in the posts smaller to fit.
Chris
Reviewed in the United States on August 16, 2022
Was very surprised how easy these were to install and kept my deck railing very sturdy. NO, you DON'T need to trim your 4x4 post, they are very snug as they should be and held them up level and tight while I screwed them in. Highly recommend.
Sharon R Thomas
Reviewed in the United States on July 11, 2022
The media could not be loaded.
Recommended Products