Your cart is empty.
Your cart is empty. Feature:
Power: 150W
Voltage:AC110V (No need power supply )
Color Rendering Index: Ra70, PF: > 0.93
Color Temperature: White 6000-6500K
Beam angle :180 degree
Lifespan:10,000hrs
Housing material: Aluminum
Luminous Flux: 100lm/W
NO need power supply, contact 110V AC directly, for DIY
How to use:
1. soldering the wire to the L N point.
2. paste the thermal silicone grease to the back of LEDs.
3. install the LEDs to the heatsink or your floodlight.
4. connect to AC110V, start working.
Applications:
Widely used in Traffic lighting, Landscape lighting, advertising lighting, Indoor Lighting, Special lighting,Landscape scene / spot lighting,Architectural lighting,Display scene,Artwork lighting,general lighting,Amusement park scene,Aquarium lighting and so.
Package Content:
1 pcs * Led Chip
Decius
Reviewed in the United States on September 17, 2024
I've been using these to repower if you will burned out led flood lights . Work great.
Cadplot
Reviewed in the United States on May 30, 2024
With a huge heat dissipation surface of a large aluminum lamp, perfectly screwed, it turns off constantly, lighting for no more than 3 minutes, and turns off due to overheating. It's a shame because it lights up very well. Since I installed it after 30 days I can't return it—wasted money.
TDS
Reviewed in the United States on May 12, 2024
The light output from this 150W 110V LED unit is really amazing; you can flood a small area even without reflectors or diffusers. Note that this performance requires adequate cooling; I've burned-out two of these because I thought heat sinks would be sufficient, but no (so it's my own fault).t this unit runs so hot that it requires active cooling (fan+heat sink).
Mike Norton
Reviewed in the United States on April 8, 2024
Nice white light easy to install
Tiny
Reviewed in the United States on November 2, 2023
Super bright...Gets hot in a few seconds so needs a good size heatsink....
☠ Sparky
Reviewed in the United States on March 5, 2022
Easily outshines a 500w halogen fixture!I gutted an old 150w HPS fixture and installed a 1/4” aluminum plate to use as a heat sink. I installed the led array directly on the plate. I used thermal paste on all contact points between the plate, fixture and led array.I’m using this to replace a 500w halogen fixture that was lighting a 25’x25’ area. The new led array produces far more light than the old fixture, using 1/3 the power and creating far less heat. It’s like having a stadium light in my back yard!
Danej540
Reviewed in the United States on March 27, 2021
Bada**! Love this thing. Highly recommend.
Recommended Products
