Shopping Cart

Your cart is empty.

Your cart is empty.

#6 High Temp Roof Boot Kit, Fits Pipe Diameters 5' - 9' Wide, Includes High Temp Round Metal Roof Flashing Boot, NovaFlex Sealant and Roofing Stitch Screws, Gray

4.8 (3) Write Review
Free shipping on orders over $29.99

$83.74

$ 37 .99 $37.99

In Stock
  • KIT INCLUDES - (1) #6 Round Metal Roof Boot | (1) NovaFlex Roof Sealant | (45ct) 1-4" x 7/8" Roofing Stitch Screws | (1) 5/16" Magnetic Socket Nutsetter | Base Width: 12.50" | Pipe OD: 5" - 9" | Max Temp: 500 degrees Fahrenheit.
  • HIGH TEMP RUBBER ROOF BOOT - Made with quality silicone, this roof boot is designed and tested to withstand continuous temperatures up to 500 degrees Fahrenheit. These boots also hold up well against ozone, UV rays, and other outdoor elements
  • FLEXIBLE BASE - The metal roof vent boot is made with an aluminum base that conforms to any style of corrugated roofing material. Simply adjust the base to fit the shape of the metal surrounding the vent pipe and fasten it using the stitch screws.
  • TIGHT SEALING - This metal roof pipe flashing boot kit also includes a tube of urethane sealant from NovaFlex that creates a tight seal between the roof vent pipe boot and the metal sheet.
  • EASY INSTALLATION - The chimney pipe boot is designed with clear diameter marks on the rubber for easy identification and cutting to fit around your roof pipe. Ideal for a metal roof stove pipe boot, chimney pipe boot, and other high-temp vents.


Product Description

Fasteners Plus logo with graphics. Find it Fast. Get if Fast.

An all-in-one kit that includes everything you need to get the job done right

Image of rubber roof boot, screws and an impact driver

Easy to Install Kit

It doesn't get much easier than this. This kit includes a high temperature silicone roof boot plus everything you need to do it yourself.

Rubber roof boot, metal screws and a tube of adhesive caulk

Includes Screws and Sealant

Kit includes the roof boot, high quality metal roof screws and a tube of premium metal roof adhesive sealant.

Clear diameter marks on the rubber for easy identification and cutting to size

Just Cut to Size

All you'll need to do is measure your roof pipe then cut at the easy to read measurement markings molded into the roof boot with a knife.

Screwing a rubber roof boot to a metal roof panel

And, Attach with Drill/Driver

Then slip it over your roof pipe, apply the adhesive sealant at the base, and attach with the included screws...spacing approximately 1-1/2" apart.


Larry Licastri
Reviewed in the United States on December 3, 2024
The boot molded nice to my metal roof, even with raised seems. I like that it comes with the silicone, screws, and driver. Nice fit!
chris Henry
Reviewed in the United States on October 19, 2024
Sturdy made. All the parts you need to install.
Terry T
Reviewed in the United States on October 18, 2024
Installed and fit easily over flu pipe. Good product so far we will see how many years the boot lasts. Would recommend for those who have metal roofs. Seems to be a good sealing set up. Showed up on time to finish the job before the frost hits.