Your cart is empty.
Your cart is empty.Js3rra
Reviewed in the United States on May 26, 2024
Good quality
Jose .
Reviewed in the United States on April 3, 2024
excelent
Dan
Reviewed in the United States on April 29, 2024
I should have gotten this kit a long time ago. It made valve stem removal and installation a breeze compared to the times I tried replacing seals throughout the years manually. The old way with pliers would tear up the seals or break them into dozens of pieces depending how old they were when trying to remove them. This tool pulled them off quickly and the installer worked perfectly. Be careful that you don't smack yourself in the face when the seals "let go" from the guides.
Mary L.
Reviewed in the United States on September 16, 2023
I tried 3d printing my own tool to pull the valve spring retainers, it worked KINDA... but putting the retainers back in was a nightmare. I ended up cutting a piece of rod off thats almost the size of the hollow end of the tool (not the pliers..), then attaching it to a spring and using epoxy to attach them both to the hollow end. This kept some kind of pressure on the retainers as you push the tool onto the spring seats to keep them from popping out. Once I got the method down and had my modified tool, it took no time to get through the project on both my 2JZGTE and my sons 1JZGTE. its good, but it could be WAY better....the pliers work great though LOL make sure you use a light to check the valve stems for any residual seal material after each one!!! i had to use a pick on almost every seal on one side, I think it was the exhaust side, but its been a while now.
William R. Mathis
Reviewed in the United States on December 22, 2023
Valve seals installation in racing heads.
tonahtiu arturo ramirez romero
Reviewed in Mexico on September 3, 2021
Me parecio un buen producto, sin embargo las pinzas tienen la punta chica para válvulas de montero mitsubishi 2004, si las puede agarrar, pero al tener mayor diámetro el sello de válvula al quitarlos los maltrata con la pinza por ser de diferente tamaño, pero si la quita
Paul K.
Reviewed in the United States on September 14, 2021
I used this tool to remove and install new valve seal on my intel 20 hp ohv engine , tool works excellent altho I had to put the hot wrench to old seal sleeve to remove it, and the istallation was very simple to do for new seals. Price was perfect also, delivers quikly as well . No dislikes. Would recommend to freinds
Customer
Reviewed in Canada on October 21, 2021
worked fine , great box to store it after
Keith
Reviewed in the United States on October 13, 2021
The pliers worked fine, removing the seals worked great. My valve guides have a 5mm bore, and the 5mm driver tool was just slightly too big to fit. I had a 5mm drift on hand so I carefully used that instead. A little disappointed.
S. Tum
Reviewed in the United States on September 16, 2020
It comes in a case.I only bought it for the valve seal pliers. I put duct tape on the outside of the jaws to keep the bores safe. The pliers rock! They are super strong and took the valve seals out of my DOHC 7mgte like nobodies business. I’m sure the installers would work well, but they are not deep enough to install with the valves in the head. So 11mm 12 point deepwell it is.I would buy again just for the pliers.
Jorge Gustavo Arriaga Rivas
Reviewed in Mexico on August 18, 2020
Buen producto muy bn empacado igual al que muestran en la publicacion
Recommended Products