Shopping Cart

Your cart is empty.

Your cart is empty.

ALL-CARB Carb Carburetor Repair Kit with Float Replacement for Johnson Evinrude 9.5hp BRP OMC SysteMatched 1964-1973

Free shipping on orders over $29.99

$10.13

$ 4 .99 $4.99

In Stock

About this item

  • Carburetor repair kit with float Replacement for Johnson Evinrude 9.5hp BRP OMC SysteMatched 1964-1973
  • Replacement for part numbers 382048
  • Kit includes float, gaskets & needle & seat, each 1 kit will repair 1 carburetor
  • Easy to install and reliable to use,professional installation is recommended
  • Please verify this is the right part number before ordering



jcdiver
Reviewed in the United States on January 10, 2025
Same as most none of parts fit my 71 9.5 a few gaskets but rest incompatible not worth sending backing but better to order oem if possible.
Phil B
Reviewed in Canada on July 6, 2024
The thread for the float needle screw is incorrect so had to re use the original. Also the small caps (2 on this model) the bigger one is too small so dont remove yours before checking. Gaskets line up well and float is good
Scott dekker
Reviewed in Canada on June 4, 2024
Jet seat is the wrong thread, fuel pump gasket is wrong, aluminum plugs are too small and fall right in. Do not buy if you don't want a headache
Hewismayer
Reviewed in Canada on December 30, 2024
As I said in the title, all screws or thread is metric. So it doesn't fit. The pin for the float is too short. The gaskets and float is about all you can use and washers. I have given it 2 stars because the float is plastic, not cork and the gaskets fit. So the needle and seat are junk! This company in China should do research and make sure there carburator kit fits the carburator that's intended.
Chvyguy22
Reviewed in the United States on December 21, 2024
Four stars only because the new jet did not fit in a 1972 johnson 9.5 but other wise good
LS
Reviewed in the United States on October 14, 2024
Only thing I was able to use in the kit were the gaskets. The needle seat would not screw in. The bigger welch plug didn't fit tight after expanding. Float might have worked but decided not to use it especially after I couldn't use needle and seat. Poor
Mary T.
Reviewed in the United States on July 29, 2023
Exactly what I needed. Quality quite good.
Tony Williams
Reviewed in the United States on January 3, 2023
Everything fit fine except the metal plugs. They were to small. I had to reinstall the old ones and solder them back in.
Customer
Reviewed in Canada on January 13, 2023
Well , float is not designed properly. Needle seat threads are the wrong pitch. The gasket to base was ok? Maybe. Had to reuse all the 1967 parts less gasket.
mark b.
Reviewed in the United States on August 29, 2021
Needle jet didnt fit in my 67 evinrude 9.5. Have to buy an own now
Steven
Reviewed in the United States on July 5, 2021
The needle seat isn't properly threaded. I had to use the old seat with the new needle.
mbluebug50
Reviewed in the United States on September 28, 2020
was very pleased with the kit it worked great.