Your cart is empty.
Your cart is empty.E-z Change router bits are an economical alternative to standard router bits. They feature replaceable head carbide Tipped cutters, saving you money by replacing only the cutters when the knives become dull, instead of the entire tool. You won't need a second bit while yours is in the sharpening shop; instead, just change the cutters. You won't even lose your set-up because the E-Z Change cutters can be replaced with the bit in the router collet. The interlocking hex design guarantees that the cutting surfaces will not slip during use., #47178, diameter (D) 5/8, angle (a°) 10°, cutting Height (B) 1/2, shank (D) 1/4, overall length (L) 2, 47178 carbide Tipped 10 degree bevel Cutter assembly (Replaces ocemco #ta-151)
ES
Reviewed in the United States on March 29, 2025
Works well for a few things, bearing overheated and burned out after about 6 linear feet of thin high pressure laminate trimming.Will be looking for another solution from here on out...
Pod
Reviewed in the United States on November 10, 2024
Worked great on some cabinet doors I made.
Customer
Reviewed in the United States on December 4, 2023
Great tool
KT
Reviewed in the United States on September 2, 2019
Not sure how often I will need this bit, because it was for a 10 degrees angle on the edge of a shelf. But it cut clean and nicely on Ash. Amana is a great tool brand, so anything from them is sure to be a good quality product (I have never been unsatisfied from anything from this company).
Recommended Products
