Your cart is empty.
Your cart is empty.Product Description
Compatible with Chevrolet Models:
- 2006-2011 Impala V6 3.5L OHV Naturally Aspirated
- 2006-2007 Monte Carlo V6 3.5L OHV Naturally Aspirated
Kit Parts Included:
- 1x Transmission Mount Part Number# A2818, 2818, 11220ET01A
- 1x Front Left Bracket Part Number# A5263, 11380ET000, 3104
- 1x Front Right Bracket Part Number# A5263, 11380ET000, 3104
- 1x Front Right Motor Mount Part Number# A2796, A2796HY, 2796
- 1x Front Left Torque Strut Mount Part Number# A5372, 10345905, 3090
- 1x Front Right Torque Strut Mount Part Number# A5372, 10345905, 3090
Transmission Mount
Part Number:
A2818, 2818, 11220ET01A
Front Right Motor Mount
Part Number:
A2796, A2796HY, 2796
Front Left Torque Strut Mount
Part Number:
A5372, 10345905, 3090
Front Right Torque Strut Mount
Part Number:
A5372, 10345905, 3090
Front Left Bracket
Part Number:
A5263, 11380ET000, 3104
Front Right Bracket
Part Number:
A5263, 11380ET000, 3104
MomDukes
Reviewed in the United States on January 8, 2025
I’m not a mechanic but my car is doing just fine
JG
Reviewed in the United States on January 21, 2025
Bottom mounts do t line up exactly right Did cure my problem
Raymundo Isaac Vallejo Fontecilla
Reviewed in Mexico on January 10, 2025
Me sorprendieron, hasta el momento funcionando al 100, creí que eran mas sencillas por el precio pero no, resultaron mejor de lo que esperaba.
cody blazek
Reviewed in the United States on August 7, 2024
Good set except the mounting bolts on the new mount are 10mm x 1.25 and the factory bolts are 10mm x 1.5. They don’t send new nuts so it was a bit of an inconvenience.
William Robinson
Reviewed in Canada on August 5, 2024
Ordered this engine mount kit for Chevrolet impala and studs were coarse thread on the top and fine tread on the bottom. original were all coarse threads. Also the studs were 1/4 " further apart. Would have been helpful if fine thread nuts were supplied. Also the transmission mount stud started turning in the mount when tightened.
Richard Beauchene
Reviewed in the United States on December 9, 2024
It's a tough install but it's worth it engine stability and performance.
JD
Reviewed in the United States on December 10, 2024
No issues with the parts or quality of parts per the mechanic that put them in.Car now runs like new.
Ep
Reviewed in the United States on October 22, 2024
They were very easy to install. The bottom mount did give a little challenge to get installed, but otherwise no more rocking. If I had to judge, I could see these lasting a couple years before needing replacement again. Good value for the dollar if your on a budget!
Ella Sue
Reviewed in the United States on April 17, 2024
DONT BUY !!!! These mounts are not the quality that is specified. One mount the stud snapped off during assembly (Tightened by hand with small 3/8 drive rachet). Other mount the holes didn't line up exactly and the bottom studs were made at the wrong thread size. Didn't even bother to put other 4 mounts on after this. Spend a couple bucks and get american made.
Eduardo alfaro
Reviewed in the United States on December 31, 2023
Transmission mount and motor mount near harmonic balancer were both bent. Had to apply some pressure to realign the bolts to the chassy/frame. Did not sit well on the balancer side at all had to be set in with some applied force when the original came out with ease. If the vehicle is still with me in the future I will go OEM or a trusted brand next time.
Recommended Products
$19.55
$ 7 .99 $7.99