Your cart is empty.
Your cart is empty.These Attwood Nylon Cleats are ideal for tying off an anchor or for use during temporary docking. These reliable cleats are feature strong and lightweight nylon construction. Each cleat is 4 inches long and is pre-drilled for installation using #12 fasteners. These cleats are sold in pairs. Attwood Corporation has been an award-winning leader in engineering, testing, and manufacturing the highest quality marine products for over 100 years. We deliver safe and reliable lighting, fuel systems, water systems, seating & pedestals, swim ladders, custom upholstery, and general marine accessories that are easy to install and meet regulatory compliance.
Steeve Zamor
Reviewed in Canada on December 18, 2024
good
Doug
Reviewed in the United States on September 24, 2023
It was a little smaller than I hoped for but it was easy to install a actually works well.
steve addis
Reviewed in the United States on November 7, 2023
Works well.
DNPKY
Reviewed in the United States on September 10, 2022
These are good quality cleats that perform as expected.
charlee
Reviewed in the United States on September 1, 2022
Already broke 2 of them in short time
Diane
Reviewed in Canada on December 11, 2022
Bateau pêche
f berg
Reviewed in Canada on August 20, 2020
juste good
joe murray
Reviewed in Canada on July 6, 2020
Decent enough
Customer
Reviewed in Canada on June 28, 2020
100%
JD
Reviewed in the United States on June 11, 2020
Installed fine on my first canoe. I didn't realize how small they are, was expecting a little bigger but they work fine and look good on my canoe.
Charles Johnson
Reviewed in the United States on May 5, 2018
Life saver, I purchased these so I would be able to anchor my kayak while entering and exiting it. This seems to be one the harder things for me to do. Also when I get an anchor I can use them to tie off the anchor. Easy to install small enough to not be in the way yet larger enough to hold my kayak to the dock.
Billy
Reviewed in the United States on January 28, 2018
These are great for kayaks with track mounts or even if you have to drill through the top and add flat washers and locking nuts. Just be sure to use stainless hardware. My son tried to convince me I needed an anchor trolley on my kayak. I didn't like the idea of putting any mounting holes in the side of my kayak so I installed three pair of these on tracks instead of an anchor trolley. Once my Son saw them and how fast it is to relocated the anchor line points with cleats he decided to rig his new kayak the same way. It works out perfectly and functions as intended.Three sets of these are a fraction of the cost of a good quality anchor trolley system and only takes minutes to mount. If you have track rails in all the right areas as I do you can play around with the locations until you get them just right for your needs.
the engineer-historian
Reviewed in the United States on May 8, 2015
These cleats are of OK quality and certainly a good value for the money. However, despite the statement in the listing (as well as on the packaging) they are NOT pre-drilled for #12 screws but for #8's. I must say that #12's seemed too large for cleats this size. Eights are just right.
Recommended Products
$54.99
$ 24 .99 $24.99