Shopping Cart

Your cart is empty.

Your cart is empty.

Blaster YFS200 Case Saver Blaster Case Savers Stop The Chain from damaging The case During Chain Failure

Free shipping on orders over $29.99

$21.99

$ 9 .99 $9.99

In Stock

About this item

  • Blaster Case Savers stop the chain from damaging the case during chain failure.
  • Include aluminum and tumbled chain guard and mounting tab SUS 304 spacer and threaded stand off post And Stainless Steel hardware.
  • fit up to a 14 tooth sprocket, have to test for 15 tooth yet. These will fit with billet case saver.
  • These will also work with OEM stator cover with out cutting it. You will only need to trim the back side of the factory plastic molded case saver which
  • Not once is a SS bolt connected directly to the case and the case saver. The only direct connection point is a 30mm bottom bolt threw another spacer and into a factory unused and isolated bolt hole on the case.


Most factory bikes come with this similar style case saver, the blaster came without one. This is a needed product to save your engine, as most of you with cracked engines already know. Theirs a built in fail safe. Aluminum is soft, it will spit the chain out as it should but if for any reason it gets caught up, the plate can bend. Controversy then arose that the bolt will snap. the longer case bolt provided in the kits is only to fit the aluminum that holds the which will bend. That tab connects to an aluminum spacer tube. That spacer tube is threaded on both sides. Not once is a SS bolt connected directly to the case and the case saver. The only direct connection point is a 30mm bottom bolt threw another spacer and into a factory unused and isolated bolt hole on the case.


Hector vargaa
Reviewed in the United States on February 15, 2025
The media could not be loaded.
Kimberly S.
Reviewed in the United States on July 8, 2024
Works fine, must trim stock plastic cover, but that applies to any case saver. I used a dremel and a small cut off wheel. Any chain protection is better than the stock plastic cover
Angela Johnson
Reviewed in the United States on November 12, 2024
Fits well. You'll have to trim down the cover to make it fit. As you would have to do with the other kit that's out there.But would recommend!
T.R. Miller
Reviewed in the United States on January 15, 2024
Will work fine, a simple install picture or instructions would be helpful. Will order again.
Luke-S
Reviewed in the United States on April 4, 2024
Oem cover has a chain guard even though mine is broke. Im sure aftermarket covers are cheap enough but... Buy a good chain before this part anyway. Nice product even for a clone.
Yo
Reviewed in Canada on September 27, 2023
Good
Colby
Reviewed in Canada on July 30, 2023
No issues installing just make sure you thread lock the hardware included or it’ll seize itself there being different metal I just used the oem hardware instead it’s all good
Shawn
Reviewed in the United States on May 29, 2023
These are stolen copied parts from HPM. And these copied don't even fit right
Rebecca Zimmer
Reviewed in Canada on January 13, 2023
good product bolted right on shipped quick