Your cart is empty.
Your cart is empty.Insulate stud type connectors on alternators, starters, windlasses and high amperage devices Cable Size 8, 6, 4 Color Red.
Steve
Reviewed in the United States on December 9, 2022
Works fine for covering ground or terminal studs.A bit pricy though
Jim D.
Reviewed in the United States on May 28, 2018
Very happy with purchase. As expected.
Firelock
Reviewed in the United States on March 23, 2016
Nice quality
Thejonses
Reviewed in the United States on September 28, 2015
First and foremost, this comes in packs of two (at least mine did). I didn't see this indicated elsewhere and ended up purchasing too many, but that's ok because I'm happy to have some spares.Works great. Good quality.FYI, wire opening diameter is about 0.25", which is smaller than a lot of others and is what I was after with these. It looks like if you needed to you could carefully trim that taper to tightly fit whatever you needed, although they stretch reasonably well. The large/main diameter of the wire hole is about 0.5". Note, mine seem to be proportionally a little shorter that the picture (the length that extends down the wire).
C. Gullo
Reviewed in the United States on June 9, 2014
I did a rewiring for a dual battery setup on my boat and wound up with 4 new battery cables landing on lugged terminals. Cables were all ready made without me thinking about the need for insulation (duh). These went on over the ring terminals and fit tightly without me having to cut & recrimp new ring terminals on the cable.
David Ashby
Reviewed in the United States on November 7, 2014
Very nice, just what it was suppose to be.
Recommended Products
