REESE
Reviewed in the United States on March 17, 2025
Work well as they should. Fit properly, Easy to weld on any hull, hold up under the intended pressure. allows for the engine to turn fully.
Anna
Reviewed in the United States on January 10, 2025
I liked that it came with great quality in the product and was not dented or poor quality.
Dale Peloubet
Reviewed in the United States on July 18, 2024
Definitely helped the boat, with boyancy.
Tom mathews
Reviewed in the United States on July 14, 2024
Welded these pods on a 1652 mod v and adds a ton of stability and allows me to go much shallower !
james l barker
Reviewed in the United States on November 7, 2024
Gives that extra bit of needed buoyancy when using max size rated engine on boat
Joe
Reviewed in the United States on September 21, 2023
Could be lil thicker sheet but I’m happy with it. Planed my boat out faster med size on a 1448
Carey Hamil
Reviewed in the United States on November 25, 2023
I really wish I hadn’t made this purchase. The juice wasn’t worth the squeeze. I really haven’t notice where my boat is more buoyant, and top end has bee reduced by the amount of drag. I used the medium size beaver tails on a 18 ft Lowe roughneck 1860, 90 hp Suzuki out board. I really feelLike I should have went with the large rather than the medium. The build quality was good, and they are holding up.
Phil Light
Reviewed in the United States on April 12, 2023
The angle of the side and the bottom rake angle fit my Lowe Roughneck perfectly, with just the right rise to the rear (1/2"). They are well-made and strong enough to stand on (I attached my swim platform/ladder to the left-hand pod), and they solved the problem I was having with my stern riding too low and the boat not wanting to plane. Get them professionally welded on.