Your cart is empty.
Your cart is empty.Product Description
B-Pillar Side Molding Windshield Door Outer Trim Right
Fitment
- 2008-2016 replacement for Chrysler Town Country
- 2008-2020 replacement for Dodge Grand Caravan
Part Number:
- 5020665AC(RH)
- 926-445(RH)
- 5020664AA(RH)
- 5020664AC(RH)
Fit Position
- Material: Plastic
- Color: Gloss Black
- 1 x Right Side Outer B Pillar Trim Molding
Installation
- Open the door and remove the Tox screws near the bottom of the B-pillar. Most of the time, even if the post is pulled off, the screws are still attached to it.
- If the old pillar trim is still intact, slide it up to remove it.
- Align the replacement pillar cover with the B pillar. Slide it down, making sure the rectangular protrusions on the post trim cover line up with the corresponding slots. Make sure the screw groove is aligned with the screw hole near the bottom of the B-pillar.
- When the trim is still loose, gradually peel off the protective film on the double-sided foam tape and press the column trim firmly.
- Tighten the column cap decal with the previously removed torx screws.
Jesse Schmidt
Reviewed in the United States on January 4, 2025
Fit perfectly on our van! It was easy to install and we haven't had an issue with it in the last 7 months since we installed it.
Guadalupe Trevino
Reviewed in the United States on July 3, 2024
I like that they had part.
Love them. Used them for a baby shower..
Reviewed in the United States on July 28, 2024
Easy to install. Replaced mine one was missing from can fit perfect.
James Tart
Reviewed in the United States on June 5, 2024
B pillar molding fit perfectly. Need a small wooden block to lightly drive it in. Perfect color match.
Central Illinoisan
Reviewed in the United States on March 7, 2024
I’m a novice at car repair, but for a product that included no instructions or installation tips, this thing was a beast.It took me around 45 minutes to install and only after a break to calm down, a loss of the tape that is supposed to help hold the piece in place due to it being rubbed off, and having to remove the padding around the tabs (as another reviewer mentioned).I got it on but I don’t feel at all confident about it and it seems like this was a waste of money that I’ll just have to have redone in a short matter of time.
WARREN
Reviewed in the United States on November 6, 2024
I needed help putting it on. There are two clips that need to be pushed in at the same time pushing it down.
Joyce Blandon
Reviewed in the United States on April 30, 2024
This fit my car door perfectly
Alibaba
Reviewed in the United States on October 9, 2023
OK I just installed it - so not a performance review but an installation review.It looks identical to the original and once on (read on) it fits well.If yours broke off like mine did, there may be a piece of plastic still holding onto the screw at the bottom of the panel, which is a T-25 accessible from the inside of the door. Problem was that the broken plastic kept turning with the screw not allowing it to back out. So take a small needle nose pliers or other tool and hold the plastic in place using pressure - not really a way to grip it if broken off clean. OK, hurdle one.I had to remove the black foam cushioning from the panel along the sides of the tabs that slide into the keyholes on the door, there was no way of pushing both tabs in and then sliding them down into the keyhole with that added resistance. Add on the peel off sticky strips and there's a ton of friction to overcome to pull the tabs into the slots so that the screw hole at the bottom aligns. So...out came the Vaseline and smeared it onto the tabs and slots, got them lined up and in, then pulled down. Not end of story. The initial insert got the tabs into the slots (think power strip screw alignment that you slide into the back- anyway) but not all the way down. That was the final step of this dance - pulling down and shaking the panel, tapping the top which was protruding above the door with a block, shaking, pulling, tapping until the screw hole lined up at the panel bottom and it was set. Last thing was to get the rubber edge along the window side of the panel to not be stuck under it and done. It appears that with the tabs inserted tightly and screwed into the bottom this shouldn't be going anywhere. Any reviews that said the panel blew off - I can't see how given what it took to install and how firmly it appears to be on the door. Time will tell.
Recommended Products
$27.15
$ 13 .99 $13.99