Your cart is empty.
Your cart is empty. 1.Typical application: Hydraulic brake, power steering, fuel lines and trans-mission cooler lines, LP and natural gas.
2.Pressure: Working pressure up to 2000psi depending on Tube (O.D),Will withstand burst pres-sure 5000psi with bundy-weld.
3.Temperature Range: -65°F to +250°F,-53°C to +120°C
4.Used With: copper, brass aluminum and steel hydraulic tubing.
5.Material:
CA360 Brass
Tyler
Reviewed in the United States on February 10, 2020
Worked great for what I needed. Ended up drilling a few out for increased flow on my application, plenty of meat there to do it.
Sunny SD
Reviewed in the United States on December 19, 2020
that pattern is bad, do not try with too much force or you will strip your thread
niflheim
Reviewed in the United States on September 7, 2019
The thinnest sidewall I have ever seen on any brass fitting, much less one intended for use on a brake line.Destroyed by wrench when merely trying to thread it into an adaptor. I have never seen such a thing in my life. Pathetic.
John Gannan
Reviewed in the United States on October 6, 2019
Part was just what I wanted and delivery was very quick.
Recommended Products
