Your cart is empty.
Your cart is empty.
Package Included:
5 x Cab Marker LED Lights
5 x Soft Pads
1 x 5 in 1 Wire Harness
10 x Screws
Compatible with:
2003-2010 Dodge Ram 1500
2003-2010 Dodge Ram 2500
2003-2010 Dodge Ram 3500
2011-2016 Ram 1500
2011-2016 Ram 2500
2011-2016 Ram 3500
Specification:
Light Size: 5.54" x 3.27" x 1.5"
Hole Distance: 4"
LED Type: 16 builted-in LED Lights
Light Color: Amber
Cover Color: Smoked Lens
Voltage: 12V
DOT SAE approved and replace Part # 11516638, 15599040, 15691885, 8C34-15442-CB, 8C34-15442-AD
Any problem, feel free to message us
Customer
Reviewed in the United States on March 3, 2025
Love the look on my Polaris
Randall B Gottier
Reviewed in the United States on January 27, 2025
I had these installed for a couple months now and I really like them. Even though the lens are smoked these are bright, even better than the ones that where on the truck already. Since I was replacing old lights installation was very easy.
Dean Wilkerson
Reviewed in the United States on September 5, 2024
Mounted the lights using the factory torx head screws, they fit perfectly. They will plug directly into the factory light bulb receptacle. These lights are polarity sensitive, so be sure they come on before mounting them. They look great, work great and took 15 minutes to replace all 5 cab lights.
Mike Roadancer
Reviewed in the United States on August 13, 2024
The lights are fantastic, but the wiring harness is a disaster. The one I received had shorts in two places due to cheap splices covered with electrical tape, which ended up blowing a fuse for my front marker lights. When I tested the harness with a multimeter, it was shorted even without any lamps connected. I had to build a new harness from scratch to make it work.This product would have been 5 stars, but the need to completely redo the wiring drops it down by 2 stars.
scotty coulter
Reviewed in the United States on December 5, 2024
This was the worst wire job I have ever seen I hooked it all up the ground wire and the power wire was taped together on every light I had to take it all back out because I keep blowing fuses and this is what I found under the tape both wires touching after I fixed every connection it worked fine
Dylan O’Brien
Reviewed in the United States on April 15, 2024
Lights look really good. They dont come with instructions or a template so if you dont have a little bit of mechanical smarts or know how to use a tape measure to good then i wouldnt advise these. Also a little bit of common electronical knowledge. Just having to use a test light and tap into a wire with an in line connector is all. I am 110% satisfied with this purchase for the money and quality of the product seems to be good as well. I did notice the harness has electrical tape where the ground was tapped in so i feel that could of been a little better but no wires were exposed. Again for price of product, you cant beat it!
Jerry and Jessica Sederes
Reviewed in the United States on September 7, 2022
Bought these for my 2015 2500 crew cab and they were super easy to install! I didn’t use the wire harness at all they plugged into my factory sockets..all lights work and are bright!
Will
Reviewed in the United States on February 26, 2022
These took a little longer than expected to do because I bought them thinking it would be plug and play into my oem ones, it was not. I had to take down my headliner(I have never done it before), so that took a little longer trying to figure out how to do it. Then I took out the old wiring harness put in the new one spiced the ground wire and the positive from the oem wire to the new harness. Hooked them in ,but when I was looking at the new cab lights I saw that people were having trouble with the foam gaskets so I took off the foam ones and used the rubber ones from my oem ones. Then when I was tightening down the screws they come with rubber washers and I torqued it down to much causing one of them to break. It wasn’t a big problem ,but it was something you need to consider if you don’t want condensation in your cab lights. All in all be prepared to take out your headliner and splice a few wires. This all around took me about 2 1/2 hours but I also did it at night and couldn’t see all that well. For me this is an easy install, but could be on the harder side for more people since they were not plug and play for me. Hope this helps. Great product quality in my opinion though.
Recommended Products
$29.99
$ 13 .99 $13.99