Shopping Cart

Your cart is empty.

Your cart is empty.

Chelhead Clutch Cover Pin Kit, Easy Belt Quick Release Belt Cover Tool X3 Clutch Cover Gasket Compatible with Can Am Maverick X3 2017 2018 2019 2020 2021 2022 2023 (Pack of 11)

4.5 (6) Write Review
Free shipping on orders over $29.99

$17.99

$ 7 .99 $7.99

In Stock
  • Fitment: compatible with 2017 2018 2019 2020 2021 Can Am Maverick X3 all models, such as compatible with Can Am maverick x3 xrs/ xds/ max/ turbo r rr
  • These clutch cover pin kits will allow you to take off your cluth cover easily and fast while access the belt tool-lessly.
  • Including 11 pack, you can used in both wet and dry conditions. (Wet uses 11; dry uses 4)
  • The X3 quick release belt clutch cover pins and lanyards will hold your cover on tightly. No lost hardware during changing.
  • Stainless steel cnc pins and Stainless steel lanyards


Product Description

Clutch cover quick release pin kit can am X3

TIME SAVER- Quick Release Belt Cover Pin Kits 11 Packed- Quick Release SXS Belt Cover

  • These pins and lanyards hold your cover on tight you can adjust the pin depth to your liking to control the holding pressure of the outer cover
  • This pin/lanyard kit allow for tool-less removal of the clutch cover for quick and easy belt changes
  • Quick release pins for easy access to your clutch for more convenient cleaning and belt replacement
  • Compatible with Can Am Macverick X3 2017 2018 2019 2020 2021 All Models
X3 Clutch Cover Pin Kit

PACKING:

  • 11 lanyards
  • 11 rivets
  • 11 clips
  • 11 pins
  • 11 Washers
Clutch Cover pins 11 packed
install 11 pins

NOTE:

To install quick release studs, leace case cover and remove stock screws. Hair pin clips should fit tightly when inserted. You shold have to squeeze outer case into the inner case to install or remove hair pins clips.

To install wire lanyards, use a 1/8''drill bit to drill holes for riverts. Hole should be close to quick release stud locations in side wall of case cover. Use washers on the oppsite dise of the rivert.

Install order: rivet, lanyard, case cover,washer.


carlos abujatum
Reviewed in the United States on September 30, 2024
muy tul
Paula Robinson
Reviewed in the United States on August 13, 2024
Good product, makes getting into your clutch a lot easier.
C. J. Wessel
Reviewed in the United States on November 23, 2024
I screwed in the studs all the way, however, when I put the cover back on and insert the pins the cover isn't properly sealed and the cover is able to move around. The holes for the pins are not low enough on the studs.
This item is impressive. I highly recommend.
Reviewed in the United States on December 13, 2023
Loved these pins very easy to use
TJ
Reviewed in Canada on November 2, 2023
As other mentioned, the bolts are too long, so the cover isn't tight. I had to cut them all down. A bit of pain, but now it's tight.
Steve
Reviewed in the United States on April 14, 2022
As other reviews have stated, the pins are a bit long to really hold the cover closed tightly. I trimmed off a bit of them with the angle grinder so that they would go deeper into the housing, and now the cover is held tightly to the car. I'm still giving it a positive review because it's a very complete kit compared to the official Can Am one (which only comes with 4 fasteners for over $100) so I'm happy to simply cut the pins down a little bit to make it work.