Your cart is empty.
Your cart is empty.Club Car Fuel Tank Vent Insulation Grommet. Fits Gas Models 1982 and Up. Condition is brand New. Replaces OEM numbers: 1015139
scotty
Reviewed in the United States on November 3, 2024
I bought these for my Club Car. They fit in the tank just fine. But the event is loose in the hole had to use something to seal it better.
Rodman
Reviewed in the United States on April 9, 2024
Easy to install in the tank. The hole for the vent is too big for the vent valve . I tried the old one to see if the vents where the same and they are the same size.
Kenneth Fish
Reviewed in the United States on June 5, 2023
Fit is loose on both vent and tank allowing gas to leak when above 3/4 tank. Overpriced for a simple grommet as I thought it was special made for clubcar. Not worth a dollar.
Boyd R.
Reviewed in the United States on December 5, 2023
Ordered vent and seal don't know witch is bad but the vent will not stay in hole. Ether seal is to big or vent is to small
Roger Seeman
Reviewed in the United States on July 21, 2022
Grommet doesn't fit vent tube, it fits the tank hole but doesn't come close to sealing around vent tube.
Alfredo Acosta
Reviewed in the United States on August 29, 2021
Fit perfect on 1999 Club car fuel tank.
JW57
Reviewed in the United States on October 24, 2021
I bought this because it was going to take a week to get it from factory. When it came in it fit the gas tank opening but when I put the vent in, the hole was too large. It should be a press fit, so I wrapped electrical tape around the vent. Made it work.
Van E.
Reviewed in the United States on January 20, 2020
A little hard putting on gas tank, but Worked perfectly
Recommended Products
