Your cart is empty.
Your cart is empty.
Specifications:
- Model : Automatic tool setting
- Color : Black + Silver
- Material: Grinding 4S+ superhard alloy
- Output mode: normally closed
- Normally closed specification technical parameters
- Output mode: BNC (normally closed)
- Pre-trip: almost zero
- Stroke: 5mm
- Repeatability: 0.001mm (condition: operating speed 50-200mm / min)
- Contact life: 3 million times
- Protection structure: IP67
- Contact force: 1.5N
- Contact material: super hard alloy
- Housing material: grinding 4S
- Contact rating: DC24V 20mA (MAX) (recommended value 10mA) resistance load
- Cable: 3m oil resistant °4 core ∞5 tensile strength 307N minimum bending radius R7
- Protection tube: minimum bending radius 1 m R25
- LED light: normally open
- Alarm signal when the trip is exceeded
- Output mode: BNC (normally closed) (2.5mm from the measurement signal)
- Contact rating: DC24V 100mA (resistive load)
Installation instructions
- the props and the tool setting device must be perpendicular to the contact surface, and vertically contact the contact surface, please install as much as possible on the workbench where the iron filing area is small.
- please be sure to use the voltage within the rated power supply range, please control the DC10-30V, the current is below 20mA, the ambient temperature range is -25° C-70° C. 3. Please control the cutter tool diameter below 20mm and the cutter speed to be below 50-200mm/min. The tool center should fall to the center of the tool face
- When using the blowing function, the air tube has a diameter of 6 mm and an inner diameter of 45 mm. Take care to remove the iron filings and cutting oil attached to the contact surface.
Recommended Products
$164.43
$ 64 .99 $64.99