Your cart is empty.
Your cart is empty.Most Popular Use is for Hinge Side Seal Bulb Compresses When Door Closes Applies With Very High Bond Tape 95" Stock Length CRL Translucent Vinyl Bulb Seal can be used on in swing or out swing doors. CRL Large Translucent Vinyl Bulb Seal has a rigid 3/8 inch (10 millimeter) wide back with 7/16 inch (11.1 millimeter) tall bulb. Cat. No. SDLB closes gaps from 3/16 to 3/8 inches (5 to 10 millimeters). Adhere rigid flat base to glass edge or wall using our Clear Very Hi-Bond Tape (sold separately) Color: Translucent Stock Length: 95 in Closes Gap: 3/16 to 3/8 in Minimum Order: 1 Each (95 in long)
Paul
Reviewed in the United States on February 22, 2025
Very fast shipping!!! Great product!!!
M. Waters
Reviewed in the United States on September 7, 2024
The measurement provided for this product matched the old seal. During the installation of the new seal, after inserting the first 8 inches in the track an inconsistency in the seal became evident as the edeges of the seal began to chafe at the beginning of the aluminum track where the lead portion of the seal slid in fine, indicating an inconsistency in the width of the product. I tried adding some lubrication to the track, but it would not fit and the spine of the seal wound up breaking maling it totally useless. Waste of time and money.
koala lover
Reviewed in the United States on March 28, 2024
Good product and fast delivery
Raymond Tomco
Reviewed in the United States on April 9, 2024
This product does the job! It was the perfect thickness and extra long to make it an even better at its job
Dr. Linear
Reviewed in the United States on September 15, 2023
The product was wider than the description and did not fit in channel. 10.6 MM as measured with a caliper and not 10mm as shown in the diagram.Used a utility knife to shave material off on each side and it fit the channel perfectly. This will need to be done several times until enough material is removed. Pack your patience.
Jess
Reviewed in the United States on April 30, 2021
Size and length is accurate. I used this to close a gap at the bottom of my shower door. Water would sometimes find a way out, and this has completely solved this problem. There is no adhesive tape attached because this is designed to fit in a track. Get some VHB tape if you plan to use this in a manner other than intended, I used 3M clear VHB tape and it worked perfectly.
Carolyn H.
Reviewed in the United States on August 5, 2019
It fits the 3/8" slotted track in the metal strike jamb of my shower door. It will do the job just fine, and I appreciate that. However, the extrusion is sloppy. Some of it is centered on the 3/8" base, and some of it is offset to the right or left by more than 1/8". In some cases, this won't matter, since the depth of the seal is consistent, and that's most important for a uniform seal against a door. I am wondering if the company realizes the extrusion has a problem?
Shu Pan
Reviewed in the United States on November 22, 2019
The seal base is actually 7/16 inch wide rather than 3/8 as stated in the picture. I had to cut off a strip to slide it into the seal slot on my shower door..
Recommended Products
$158.88
$ 62 .99 $62.99