Your cart is empty.
Your cart is empty.Oil Fill Tube and matching push-in Breather is an original style for vintage manifolds with a 1-1/4in. oil breather hole.
Diego Avalos
Reviewed in the United States on February 18, 2024
The bottom end that goes into the intake is a little on the big side needs some modification to make it fit. Oil cap fits a little lose.
Patrick
Reviewed in the United States on April 28, 2024
Fit as it should
Customer
Reviewed in Canada on August 11, 2023
Worked perfect
jiggy
Reviewed in the United States on December 19, 2023
I have too make a bushing so that it fits the edelbrock intake.
Dan
Reviewed in Canada on September 23, 2022
You need a 1.5" filler tube, this is 1.25" and not even close. No one including Edlelbrock seems to make this size of tube. cap can be used on a 1.5" tube so its not a total loss I suppose :) expensive cap though!
Anderson
Reviewed in the United States on July 20, 2022
Had to make a relief cut in base in order to drive into the 327 block. Otherwise perfection. Likely perfect size prior to being chromed, to give perspective on size variation.
michael sicurella
Reviewed in the United States on June 26, 2022
Fit and looks great
MWO
Reviewed in Canada on December 30, 2022
The tube was great. The cap was garbage. It was not a solid fit at all. The two trash clips that are suppose to hold the Cap in place, not worth talking about .If you drove your classic car down the road it would blow the cap off and your engine would be full of oil..Trash stuff..
Priceless Farming
Reviewed in the United States on August 19, 2021
Used this on our newly acquired 1958 Case 420B backhoe and it fit perfect. The previous cap was too short so this extension was exactly what I needed. It fit perfectly.
Julián Cermus
Reviewed in Mexico on May 5, 2017
La tapa parece de plastico y el metal deberia de ser de un calibre mas grueso, aun asi cumple con su funcion.
Scubadude
Reviewed in Canada on December 15, 2016
Edelbrock fill tube for an Edelbrock intake. Doesn't fit. Would be nice if the description included measurements
Bobbi Manning
Reviewed in the United States on December 29, 2014
This fit my new engine perfectly after a little bit of trimming. After the pain it was to find this, it was a pleasure installing. It got here exactly when i needed it to be here as well.
Nick K
Reviewed in the United States on March 22, 2012
When i dropped my manifold and broke my stock tube and crushed my breather cap i thought i'd have to spend a lot of money to find one that would fit. this said it would fit, and it did. i couldnt be more pleased. i just wish it could've been less round like the stock one.
Recommended Products
$75.99
$ 35 .99 $35.99