Your cart is empty.
Your cart is empty.
Product Description
Fender Eliminator Kits Accessories For Yamaha YZF-R25 2014-2024, YZF-R3 / MT-25 / MT-03 2015-2024.
Please make sure your motorcycle is compatible before purchasing
Fitment:
For Yamaha YZF-R25 2014-2024
For Yamaha YZF-R3 2015-2024
For Yamaha MT-25 2015-2024
For Yamaha MT-03 2015-2024
Features:
100% Brand new
High quality
Add welds on the back of the tail tidy. Avoid vibration and noise during driving.
Installation steps: straightforward with the installation. Unplug all stock wiring, filter out of the tail, take off the fender, take off blinkers and tag light from the stock fender, install plate, tag light, blinkers, filter wires back up into bike, and tighten the bolts!
Specification:
Color: As Pictures
Material: Aluminum
Package Includes:
1 * Motorcycle license plate holder
Note:
Please feel free to contact us if any questions about the fender eliminator kits , we will follow your case until solved.
Customer satisfaction,our greatest happiness.
Please allow 1-2mm error due to manual measurement.Thanks for your understanding.
xiiztec
Reviewed in the United States on December 5, 2024
Yes it’s compatible with the bike, but took over 2+ hours to install. Unless you purchase their light kit, be prepared to hand file to make your OEM fit, not as easy as the description describes. Your OEM plate light also won’t fit, be prepared to buy that separately. The hole to run the indicator wire back inside the bike isn’t big enough for the connector to go through, forcing it damaged the connector, so you have to hand file and keep trying, over and over again; until you’ve filled the holes enough to squeeze the connectors through without damaging it. There’s no extra protection, so the hole spaces after reconnecting to bike are still wide open and the wiring is exposed, versus the oem that has an additional cover to go over it all. The screws to hold the assembly into the bike frame are too long, so you’ll need a pliers to hold the nut while bolting in. Speaking of nut, hold on to your OEM ones. The ones that come out with the kit are defective and don’ts screw in all the way, had to toss then. If I hadn’t already stripped my bike, I would have never installed this and just send it back. I’ll definitely be replacing it with something else. This was more than a waste of my time, I absolutely hated this thing, and the entire experience. I don’t see what I paid for; had to modify everything myself, might as well had built it myself.
Recommended Products
