Your cart is empty.
Your cart is empty.
Replace Part Number:
68269523AD, 04727370AA, 4727370AA, CBWPR091AA, CSZDV621AA, CBP4P541AB
Compatible Models:
Compatible with Dodge Durango 2011-2013
Compatible with Chrysler Town & Country 2011
Compatible with Dodge Grand Caravan 2011
Compatible with Jeep Grand Cherokee 2011
Compatible with Ram 1500 2011.
Package Include:
1X Relay Wiring
1X Relay Block
4X Cable Clips
4X Heat Shrink Tubes
3X Locking Strip
Installation steps:
1. Pre-installation: Before starting, ensure that your vehicle is safely parked and the engine is turned off, and take necessary safety precautions.
2. Engine hood entry: Gently open the car's engine hood to enter the engine compartment.
3. Positioning relay: Follow the instructions of the car manufacturer to locate the fuel pump relay, usually located near the electrical box in the engine compartment.
4. Disconnect the old relay: Carefully disconnect the existing fuel pump relay connection, taking care not to damage any cables or connectors.
5. Connection Wiring Kit: Connect the wiring from our advanced fuel pump relay wiring kit to the existing wiring. Ensure accurate and safe connection through the correct plug.
6. Check connections: After completing the relay connection, thoroughly inspect all connections to ensure they are safe and correctly installed.
7. Final check: Before continuing, carefully check each step to ensure that each connection is correct and secure. Remove any tools or materials from the engine compartment.
8. Close the hood: Once you are confident that all connections are in order, gently close the car's hood.
9. Function test: Start the vehicle and check if the fuel pump relay is working properly. When the oil pump supplies oil to the engine, you should be able to hear the sound of it running.
Bobby Bright Light
Reviewed in the United States on February 26, 2025
It's a bit involved to install though not overly complicated. Excellent solution to the problem.
Bernard B.
Reviewed in Canada on September 9, 2024
Did not work had to take back out and put a bypass link in.
Engine Shop Joe
Reviewed in the United States on February 9, 2024
The media could not be loaded.
Nigel
Reviewed in the United States on January 30, 2024
I got this because I wanted to wire some Hella super tones and honestly didn't want to make my own harness.This is already wired with everything need, I just needed to solder/extend the wires. Nice thick battery gauge. Relay is completely sealed. And it's wired as a 4 pin relay.Can't fault anything with this. It works just as described for my need with supertones!
Recommended Products
