Your cart is empty.
Your cart is empty. Specification:
1. Max Voltage: 125V
2. Max Current: 1A
3. Board size: 20 x 20 x 7 mm/ 0.8 x 0.8 x 0.3 inch
Feature:
Type: limit switch (3pin) with LED light
Material: metal & plastic
Port: XH2.54 3PIN
Colour: Black
Ambient temperature: 0-40℃
Service life: 10000 hours
Applicable 3D printer models include: Ender-3 Ender-3 Pro CR-10 CR-10S CR-10S Pro CR-S4 CR-S5
Package includes:
3 x 3D Printer limit switch only
DMW
Reviewed in the United States on June 7, 2024
These switches did work for the x-axis on my Ender 3 Max Neo, but not out of the box. There are 3 chip capacitors that must be snapped off the circuit board; C104, 1K and 10K. The LED can remain. If they are not removed there is a resistance left in the circuit when the switch is activated. Just use the cutters that came with your Ender and carefully and easily snap them off, it takes very little effort. Referring to the image, the new board shows the capacitors in place and there are 2 loose ones that I removed from the one I installed to the right of the switch. The third went into oblivion. Look at your original switch to compare, my original had no capacitors and after checking the circuits with an OHM meter I confirmed the issue when comparing the readings with the original.
Andrew Broekhuijsen
Reviewed in the United States on April 3, 2024
After 5 years, my z endstop went out on my Ender 3. These were a cheap drop-in replacement that worked exactly as intended.
Jackey farthing
Reviewed in the United States on December 30, 2022
Need to replace limit switch on a ender 3 work fine good value
jay
Reviewed in the United States on August 23, 2021
I used it to replace a broken part on my 3d printer. Honestly it runs really smooth and everything comes together like it was sent with the printer.
Nathan Bonsal
Reviewed in the United States on December 21, 2021
Two screws, one easy connector, and boom, you're back in business. Good build quality, dimensionally correct.
Marie Oliver
Reviewed in the United States on April 21, 2021
Got these after I accidentally broke my Ender 3's endstop switch off while assembling. Got these and it works just like the original! You'd never know the difference. Fast shipping,very friendly and responsive customer service and the free gift arrived even quicker! Great company...give them a try!
WBG
Reviewed in the United States on February 24, 2020
I accidentally broke one of the stop switches while assembling my Ender 3 Pro. This was a direct swap part and has been working perfectly.
Cecelia W.
Reviewed in the United States on November 20, 2020
When you have to use an alternative part not purchased from original manufacturer of your printer it’s always a hope wait and see situation. But not with these endstops. They worked as though they came with my printer and were super simple to install only took two minutes total time.
Recommended Products