Your cart is empty.
Your cart is empty.I2C Wii WiiChuck Nunchuck Adapter shield Module Board for Arduino
Alex Corona
Reviewed in the United States on March 18, 2025
It wouldn't read the data. Maybe it was just me but I could get it to read. The power was on and off for this item. I have a pi 3 b+ had a fan going turned it off to make sure no power issues and nothing else plugged in. The light for power on the controller would come on and sometimes not at all when I tried to reboot. Wouldn't read any of the joysticks movements or buttons. It could be a bad board. It would cost more money in time and gas to do a return for this. Others got it to work but not me. I even went from the 3.3v to 5 volt pin just to be sure and yeah nothing changed. I am able to run a fan, 1 usb storage, and 1 usb wired controller normally and no power issues.
Ayush Shah
Reviewed in the United States on April 15, 2023
Really simple to plug in and use. Helped me with a personal project.
Jared Korthuis
Reviewed in the United States on November 6, 2017
worked as expected.
artburkart
Reviewed in the United States on September 6, 2016
It did what it says it does.
Primo
Reviewed in the United States on March 1, 2016
Worked great. I hooked up a Wii nunchuck to a robotic arm using code found online and for a change things went smoothly.
David Baker
Reviewed in the United States on January 19, 2016
This is the easiest, best way to connect a Wii controller to an Arduino. You can connect the controller without cutting the cable. Then just unplug it from the Arduino and plug it back into the Wii. It works great.
Neil Kolban
Reviewed in the United States on April 17, 2015
Arrived safely and as described. Arrived in 2 weeks after ordering from China. The pin out wasn't clear at all.
Recommended Products
