Your cart is empty.
Your cart is empty.Product Description
The Heat 5000 12 Volt
Step up your warmth game with Maradyne High Performance's best-selling heater, The HEAT 5000! Designed for wall or floor mounting, this hydronic heater runs on engine coolant, delivering unparalleled warmth. The sleek black finish on its rigid 16 ga. steel case combines durability with style. Whether you opt for 3 vents with doors or a 2 in. outlet for flex duct compatibility, the 3-speed motor ensures powerful performance. Complete with mounting studs, rear hose connections, and the included 4-position switch (H-5670014), it's easy to see why the Heat 5000 is a customer favorite! Unleash supreme heating with Maradyne!
Heaters will keep you warm on those cold days, simply connect plumbing and wiring directly to your cooling system for immediate heat. The blower unit blows fresh air through the heat exchanger, elevating the air temperature, which then exits through the outlet louvers adding strong and consistent heat to any vehicle.
Don’t let cold weather keep you off the road or trail! Here at Maradyne, we carry dozens of automotive heaters to keep your interior toasty in the most frigid conditions. These compact units come in a wide range of sizes and configurations, with outputs up to 40,000 BTU and 300 cfm. Since they’ll fit almost anywhere, applications are nearly limitless:
- Hydronic Heater uses engine coolant for heat w/ Tube & Fin Core
- Rigid 16 gauge Steel Case w/Black Finish w/Aluminum Blade
- Heavy Duty 3" Three Speed Wound Field internally grounded Motor @3.0 Amps
- Airflow Options - Vents with doors or 2" Outlets to Use Flex Duct
- Mounting Studs & Hose Connections in Rear
- Dimensions: 7-7/156" W X 7-1/16" H X 7-3/8" D
- 13,200 BTU's/Hr @ 200 CFM
Joe Karbon
Reviewed in the United States on January 4, 2025
I put this in a skid steer with aftermarket cab. It puts out a good amount of heat. If you have a fairly air tight cab this would be great. A bit pricey but it does the job.
Vincent Vhiasson
Reviewed in Canada on August 18, 2023
fait plus de tapage que le trateur et il faut payer pour retouner va pas la peine etre acheter
Ritz
Reviewed in Canada on September 27, 2021
This replaces my old heater in my tractor cab… great quality !
Nelson Gosselin
Reviewed in Canada on August 9, 2020
tres satisfait
Michael J Potter Jr
Reviewed in the United States on March 6, 2020
The heater core leaked. I discovered the problem after I installed it. I wasted lots of time. Very frustrating.
Mypublicname
Reviewed in the United States on January 28, 2020
fit right in where the old one was and came with better controls then original
Customer
Reviewed in Canada on December 23, 2019
Very nice heater ,Very solid with control. noisy a bit
victoria
Reviewed in Canada on October 6, 2019
Came complete and was ready to install.Great value for the product
Scott
Reviewed in the United States on April 7, 2019
Works as expected but it's loud. It is fine for an old tractor to get some heat in the cab but it's loud. Very annoying on high and still very noticeable on low and I am not fussy. It works for my application but I wouldn't want it in a quiet cab. Turn up the radio.
Darren Douglas Donnell
Reviewed in the United States on December 13, 2016
Only used it once .But gives out sufficient heat.Fan is a little noisy when used on high. But over all Doing what is expected.
JJ
Reviewed in the United States on January 17, 2016
It is a heater which it does well. The only reason I can't give it 5 stars is the totally incredible amount of noise the fan makes for such a small amount of air flow. It was a bit of pain to install in my car due to the car not the heater so I am stuck with it. If I had wired it up and ran the fan first this puppy would have went back rapid.I would advise anyone buying this to wire it in and turn it on before installing it to see if you can live with the noise.
John
Reviewed in the United States on April 11, 2016
Easy install, makes heat in cab. Loud fan, however my vehicle has no insulation. I doubt I will notice the noise, warmth however is good.
KS Wenger
Reviewed in the United States on January 10, 2014
I built a cab for my Lull LD-50 end loader so I could use it to move snow in the winter. I installed this heater under the seat. It took about 9 feet of heater hose to reach the ports on the engine block. It keeps the cab comfortable down to 0 degrees.
Recommended Products