Your cart is empty.
Your cart is empty. This Diffuser Sock ringed with strong elastic fit around reflectors. Ideal for 7" (18cm) diameter standard reflectors. The diffuser softens the light output.
Specifications:
Color: white
Material: Nylon
Ideal for Haoge 7" standard reflectors and other 7" / 180mm exterior diameter reflectors.
Package Including:
1 x 7inch White Diffuser Sock
(Note: The Reflector is NOT included)
William E.
Reviewed in the United States on July 24, 2021
Fits flashpoint but doesn't soften very much
Jason!
Reviewed in the United States on June 4, 2020
These work great. Wish I had more need to use them. They're so much better than using a scrap of diffusion and having to tape or rig it to the light. Only area for improvement is they are a little tight. I sometimes worry it's going to break as I stretch it onto the reflector.But definitely grab a few of these. It's one of those things that when you need it, you're glad you have it. And it's so cheap that you might as well have it just in case.
a.g.
Reviewed in the United States on February 29, 2020
Holding up so far. I've been keeping the modeling light off to avoid burning it. I used to just pin a diffusion fabric over my background lights and it was very messy looking and would get burned, this definitely solved both problems, and its shooting just the same.
Ron
Reviewed in the United States on March 21, 2019
I thought I was ordering a reflector with sock. If you need a reflector and sock, there are lots of options for not much more money. If you need sock only, then this is a good choice. It does fit my reflector just fine and is pretty easy to install.
Jacob & Alissa Briggs
Reviewed in the United States on December 18, 2019
They definitely do what they are supposed to do! Sadly, they don't work well for what I needed, but... that's my fault! :-P
Reginald Graddy
Reviewed in the United States on August 1, 2018
Very good product for diffusing my slave domes. I just need more of them. These are a good way to diffuse light on any smaller devices.
David W. Johnson
Reviewed in the United States on January 7, 2018
Works great on a table lamp that I have sitting above my line of sight. Takes away the harsh glare of the light.
Margie
Reviewed in the United States on August 31, 2017
I bought these for my Phottix Endua strobes, and they fit perfectly and give nice diffusion when using a bare reflector would be too harsh.
Trev-R
Reviewed in the United Kingdom on February 6, 2017
This sock works well on most of my 7" reflectors but on one it was very tight to get on. I would say this is an odd reflector rather than a fault with the sock.The only suggestion I would make is NOT to leave your modelling light on with the sock in place. Do a lighting check then switch it off.
Kevin
Reviewed in the United Kingdom on April 28, 2017
Does the job well
Recommended Products
$38.02
$ 16 .99 $16.99