Your cart is empty.
Your cart is empty.HD Switch Spent Two Years Designing, Developing and Testing The HD Switch 10 AMP Series PTO Switches. This Design was Successfully Tested to 200,000 Cycles at 10 Amps, and Salt Spray Tested for 72 Hours to achieve IP53 Water Tight Certification. Most Factory PTO Switches are ONLY Rated at 5 AMPS; which is less than the fuse in most machine circuits. The HD Switch 10 AMP Water Tight PTO Switch is a Tough Upgrade Replacement. HD Switch - Engineered Performance
Dennis Cowling
Reviewed in the United States on September 12, 2024
Easy to install
Lee M.
Reviewed in the United States on August 25, 2024
Easy to change out, just snap it in.
dugr42
Reviewed in the United States on August 16, 2024
It's a quality switch. The only noticeable difference from OEM is the pull knob is smaller with this one.
Jack
Reviewed in the United States on June 5, 2024
Switch works fine it was however difficult to install through the hole where the old switch was removed. I had to file a little off of the clips that hold the switch in place however it works fine. Thanks I would by again if needed.
Marcos Nevarez Jr.
Reviewed in the United States on June 29, 2024
Fit perfectly and works great and great valve would definitely recommend.
Dalton
Reviewed in the United States on November 3, 2024
Quality
Dawn
Reviewed in the United States on November 13, 2024
The lawnmower blade wouldn’t engage and this was an easy fix.
Average Joe
Reviewed in the United States on November 14, 2023
This is not the same as the original at all. It does not fit at all. Don't get me wrong, it's made to but the poor quality of the manufacturing process stops it from installing in the spot. After I got it in, the bottom guts of the switch fell out. It's usless. Don't buy.
Recommended Products
