Your cart is empty.
Your cart is empty. High Pressure Oil Pump HPOP Hoses Lines Kit
Compatible with 1999-2003 E-350 Club Wagon
Compatible with Ford E-350/450/550 Super Duty
Compatible with Ford Excursion
Compatible with Ford F-250/350/450/550 Super Duty
Working Pressure: 5800 psi
Minimum Burst Pressure: 23200 psi
Temperature Rating: -50°F to 260+°F
Perfect 7.3 powerstroke accessories
Broken Big Guy
Reviewed in the United States on April 15, 2025
These were horrible. I put them on an engine that I was building. I installed the engine/7.3 and a week later I noticed an oil leak and it was these hoses. Every one of them leaked so II installed the engine/7.3 and a week later I noticed an oil leak and it was these hoses. One of them leaked so I upgrade it with CNC braided linesand I don’t have any problems upgraded.I definitely would not recommend these. I wish I could give them a negative star.
Jacob Yates
Reviewed in the United States on January 3, 2023
Had to go to local supplier to get the hose. It was the same price as the kit
MM
Reviewed in the United States on September 21, 2022
No complaints at first glance...the parts feel decent quality....I'll update once installed
Rynn Fuhrer
Reviewed in the United States on November 10, 2022
Nice thick quality hose, fittings are made in china, had one that the flat seat needed to be cleaned up.Glad i caught it before install
Matthew
Reviewed in the United States on October 23, 2022
Hoses are way to long they do not fit properly do not buy this product
Richard D.
Reviewed in the United States on October 14, 2022
Hoses seem to be well made. Fittings for the HPOP were fine, but the ones that screw into the heads on either side are close but not the right size/thread. You will have to source them elsewhere.
Richard B.
Reviewed in the United States on October 10, 2022
I had to get creative with the installation because they were all almost an inch too long, I didn't end up using all of the fittings because if it, and some of the hoses are at hard angles. That being said, if they fail I'll update this review. Once installed, they seem to work okay.
richard desmit
Reviewed in the United States on November 2, 2021
Not that hard to install if you are mechanically inclined. The pictures you see on other sellers are misleading. You have to route the hoses around to work. After installing my truck ran great and was quieter. Recommend changing the IPR at the same time as well as the high pressure sensor. Update, the fittings for the pump are not large enough to accommodate the check valve springs.and must be drilled larger. If not done the pressure to open the check valves is much higher and has caused my injector o rings to fail leaving me on the side of the road. Lesson learned.
Recommended Products