Your cart is empty.
Your cart is empty.Product Description
HOW TO INSTALL
PREPARATION:
- Place the vehicle on a secure ana level surface.
- Set the parking brake.
- Clean the mounting suraces betore beginning installation.
INSTALLATION:
- Crimp connect the 12-volt accessory to the Connectors and then crimp them to the Wire Harness 150mm.
- Remove the hood and access the inner firewall. Remove the nine bolts that hold thefirewall to the hood section. Disconnect thespeed key wire harness (if equipped). Retainthe stock bolts for reuse.
- Locate the accessory wire harness and connect the 1Wire Harness 150mm.
- Route the other end as needed.
- 5.Reinstall the inner firewall with the stock
bolts.Torque to 3Nm (0.3 m-kg or 2.2 lb-ft)
- 6. lnstall the hood back on the vehicle.
MAINTENANCE:
- Periodically, check torque on all hardware. If loosehardware is found, re-torque to specification.
- Clean painted metal parts with a clean soft cloth andmild soap and water solution. Rinse and dry.
- Specification: Total of all accessory powerconnections may not exceed 20 amps.
ebot
Reviewed in the United States on January 19, 2025
Plug fit correctly but after blowing a fuse found that the red wire was ground and the black one positive.
Craig D
Reviewed in the United States on September 8, 2024
Yamaha was kind enough to supply us with several “unused” power taps under the dash… these pigtails connect precisely with those taps… easy easy easy…Good pricing also…
hov425
Reviewed in the United States on September 30, 2024
Connector worked perfectly but the polarity was backwards!! Just check before installing.
Heidi Hill
Reviewed in the United States on September 16, 2023
Works great provides a waterproof connection for power to new accessories
Jamie Chachula
Reviewed in Canada on August 27, 2023
Exactly what I was looking for great quality
Jerry
Reviewed in Canada on May 20, 2023
As described just what I needed. Used for my motorcycle.
Charlotte
Reviewed in the United States on November 20, 2022
Worked perfectly
Recommended Products