Your cart is empty.
Your cart is empty.Husky Mud Guards are a perfect match for your fender; more than a match for anything the road kicks up. Delivering nail-tough protection for your truck, van, or SUV thanks to its thermoplastic construction. Engineered for the ultimate in impact resistance, plus, the added invincibility of Husky Shield for an extra layer of defense for your vehicle’s paint. Available in single or dually factory-tire width. Proudly made in the USA, guaranteed for life—like all Husky products.
K Newton
Reviewed in the United States on March 9, 2025
Installed on 2017 Ram 3500 Crew cab, long bed.. Truck has 35 12.50/20 and there is some rub when you turn wheels.. tire are down to like 30% tread so if new tires the rub would be much worse for sure..
Rocky
Reviewed in the United States on February 27, 2025
They fist perfect. No more mud on the side of ny truck.
Night Rider
Reviewed in the United States on February 26, 2025
Does not fit power wagon edition
Andrew Galloway
Reviewed in the United States on September 25, 2024
Look good easy to put on. Seams to hold up good.
AHMED ALSHEHHI
Reviewed in the United Arab Emirates on July 20, 2024
Both Front & Rear perfectly fits on my Ram 1500 2023 Warlock
mtw
Reviewed in the United States on February 3, 2024
Pretty decent fit on 12 ram 2500. Slight gap between top of mid flap and truck wheel well. Seem durable. Took 10 minutes to install. Hopefully does what they are intended to do, although I have bigger wheels
Erik
Reviewed in the United States on November 28, 2024
They do a good job at keeping the debris that flies off my tires from impacting the body of my truck
Jerry
Reviewed in the United States on October 14, 2024
Simple to install and fit great. Really like how they look on the truck too. The holes lined right up to the existing holes on the truck. Fit like factory parts but for a fraction of the cost.
Hugh Carlisle
Reviewed in Australia on December 4, 2023
Perfect fit, easy installation.
Robert Harris
Reviewed in Australia on May 28, 2021
I purchased these for my new 2020 Ram 1500 Quad Cab Express. It seems that Ram thinks you need mud flaps on the rear wheels but not the front. Fitting was relatively easy and they look good - factory finish. Recommended if you can't get factory or don't want to pay the extra for the Ram logo.
Ralf M.
Reviewed in Germany on November 7, 2021
Schnelle geliefert, die Montage war selbsterklärend, wer ein wenig Handwerkliches können hat sollte die Montage in 1 Stunde erledigt haben. Sie passen auch genau vor die Originalen Side Steps meines Laramie's.
Customer
Reviewed in Canada on August 30, 2018
Great mud flap
Willy Brownshoe Brown
Reviewed in the United States on October 29, 2014
I had been looking at multiple mud guards for my truck and finally settled on these because of the slightly rounded corners, the blocky look of other guards just didn't do it for me. They extend just a wee bit fast the edge of the truck body and moldings, and they don't look like a generic rubber flap hanging down.Install is simple: Remove two existing screws, attach guard, reinstall two screws. There is however one more screw which necessitates drilling through a plastic wheel-well section behind the actual tire and wheel. If you have a 90 degree drill you might be able to reach past the tire, if not you will need to remove the tire if you want to utilize the provided hole in the mud guard. I decided "eff that" and drilled through the back of the plastic section into the guard and made my own hole, I couldn't have cared less whether or not I lined up on the existing hole in the guard. Attached the screw through the wheel well and tightened down to the flange nut; voila, done and done.Husky also provides a sheet of plastic protective decals to protect the paint of your vehicle from the guard itself; however, this is a wet application type of decal and is sort of a pain to use. You need to wet the mud guard, peel off the decal, wet the decal, apply the decal perfectly, smooth it out with a credit card while trying to keep it from slipping around, and then wait for the entire mess to dry which can be a while.I skipped that. Instead I applied packing tape to the mud guard which is almost the same thickness as the decals, went on quicker and easier and no fussing with water or scraping out the bubbles.There is some very slight gapping between the guard and the truck but nothing to sweat over, I suppose if it really bothers you there could be some foam or something to fill up the gap.
Recommended Products
