Your cart is empty.
Your cart is empty.Noah
Reviewed in the United States on August 18, 2024
Bought these so I could correctly change my injector seals. They ruined two of them and the final calibration tool is stuck on my injector, I tried pulling with pliers and TWO people. The tooling sucks and now I have to leave all these out until I get a tool that works
keith wilson
Reviewed in the United States on March 28, 2024
It worked well
Dystinee Miller
Reviewed in the United States on March 20, 2024
Must have for injectors when installing on BMW index injectors great lil set
Customer
Reviewed in the United States on January 23, 2024
When redoing the seals on my injectors for my N54 powered 135i, I was a bit worried about it. Not necessarily because I thought I couldn’t handle it, but more than I was worried I’d risk making a mistake, especially since I’ve seen people over size the seals when using the ballpoint pen method. For how cheap it was, it was cheap insurance and did speed things up a bit!The cone slides right to the injector and guides the seal on nicely. Be careful to NOT use your fingernails to guide it over. The instructions are clear on this too. I didn’t pay attention at first and put a little bit of a crease in one of them. Using my finger pads worked well. Just barely stretches it just enough to fit over. The compression sleeve worked great too. Sliding it on carefully and letting it sit for a few minutes worked great. Install was very easy. Slide hammer tool also made life easy for removal. No regrets here.For the injector job, it’s not a bad idea to order a few extra seals. Especially if you accidentally damage one like I did. I ordered 8, though with how cheap they are, I’d probably order 12 just to have a spare set if I ever pull the injectors again. But not necessary. Also be sure to get new decoupling elements
Edgard W. Torres
Reviewed in the United States on August 21, 2023
Liked the price.
Critic
Reviewed in the United States on December 10, 2023
Worked easily removing injectors on my 2015 BMW X5 50i engine
Customer
Reviewed in the United States on December 10, 2023
Made in China but worth the money
Customer
Reviewed in the United States on July 24, 2021
Good quality, but it is not designed for n63 engine use. I had to return
Recommended Products