Your cart is empty.
Your cart is empty.InterProtect 2000E has a natural structure within the epoxy coating to create a barrier against water permeation called Micro-Plates. Technically, the InterProtect 2000E Micro-Plates formula provides millions of overlapping microscopic plates. When bound in the epoxy coating, they create a barrier similar to shingles on a roof. The Micro-Plates eliminate any direct path for water migration. InterProtect 2000E is one of the key components in the Ultimate No Sand System, preferred by first class North American boat builders.
JetPowers
Reviewed in the United States on February 19, 2025
Great price for the only product that I really knew of to do this job. My sandblasted 1yo 5-coat hull was sanded through the barrier in about 50 spots by sloppy boatyard service who will not allow me to do any bottom work and will charge me for recoating what they did, so I bought this to do the 50+ areas on the sneak. Not much to say other than it is easy to mix up even in partial quantities - I simply counted spoonfuls. It is best to be overcoated by ablative before it cures for a chemical adhesion but that was impossible so relying on mechanical adhesion of the ablative. Now that the boat has been hauled for winter it seems to have held up well over the season.
Customer
Reviewed in the United States on January 4, 2024
If you are painting a boat, you need this primer to go under your finish paint. It is very stinky, so must be applied somewhere well ventilated, and it is not cheap. But if you want a proper job that will hold up and look good, you need this primer. Read the directions carefully. This is not like house paint that can be applied in almost any weather. It also needs a good roller or brush - don't waste time with the cheap stuff.
James Nail
Reviewed in the United States on May 17, 2020
Used on my cast iron keel. I was able to get 4-5 good coats on entire keel for great primed surface for paint. Dries fast cures less than 48 hours. I will definitely use again
Bob
Reviewed in the United States on January 22, 2019
I love InterProtect. In addition to using it as a barrier coat it makes a very durable and chemical resistant General purpose primer for metals which is great in a marine environment. Where a fine finish is not required, like parts in an engine room, I don’t even use a topcoat. And it still leaves a decent, gloss free, looking finish.
Richard F. Anderson
Reviewed in the United States on October 1, 2017
Works great all the time
lindademara
Reviewed in the United States on September 19, 2016
Did tge job
Shawn
Reviewed in the United States on June 14, 2014
Applies easy, sandable after it dries, its holding up well after two years of mooring in clear freshwater. I suggest this product.
Recommended Products
$65.99
$ 29 .99 $29.99