Your cart is empty.
Your cart is empty.Jimen Compatible with 2007-2018 Jeep Wrangler JK & Unlimited, 2PCS Car Side Fender Air Vent Cover Trim Exterior Accessories (Black)
CM
Reviewed in the United States on February 2, 2025
Jeep was freshly waxed. Cleaned with alcohol. Warmed up tape and surface with heat gun. Pressed and held for 1 minute. Bottom popped up and top point lifted. Like the look but tape is insufficient. Couple of thin straps. Ordered 3m emblem tape $10.99 to cover entire backside of vent see if that works. Almost $50 for fake plastic vents. They look good from a distance. Up close they are obviously fake. No actual holes.
Laurie Harrison
Reviewed in the United States on July 2, 2024
They looked good when I put them on. How one side looks good, the otherside, well must have fallen off. 🤷♂️
terry
Reviewed in the United States on September 12, 2023
Nice addition with little effort.
Jason Clark
Reviewed in the United States on August 6, 2023
These are well designed and crafted faux vents that can help make your vehicle a bit more distinct from other similar rides. Installation is easy and secure.
Steve Denny-1978, The Norseman
Reviewed in the United States on August 21, 2023
So far so good. Fit nicely on our 4 door 2015 Jeep Wrangler. We shall see how well they stay on when we take our vacation to Destin Beach, Fl in 3 weeks I thought they were a bit pricey. But they do look good.
LauraHD
Reviewed in the United States on August 13, 2023
Little extra
Alan Garner
Reviewed in the United States on February 4, 2023
I have been looking at adding fender vents for some time to Freshen up my JK look. Installing actual JL vents would require drilling and cutting into my fender which I was not ready to do just yet. I bought these and some OEM JL vents to compare. Here is what I found:- The OEM vents are deeper and have a deeper vent/honeycomb pattern- The OEM vents are larger than these- The OEM vents have thicker plastic- The OEM vents have a texture on the plastic- The OEM vents are actual vents and look like the vent the interior of your engine bayI was also super worried a the long term holding power of the adhesive tape and the vents coming off during driving after years of use.I decided to install the OEM vents which required drilling and cutting my fenders. I found a good picture of a JL fender with the vent removed and used that (along with the OEM JL vent) to make a pattern to cut and drill holes in my JK fender to install the OEM vent. Since my JK fender now has the factor sized cut outs for the vent and using the JL OEM vents, JL vent accessories will work with it (like vent decals, lighted vents, vent overlays). It took about 2 hours to create the pattern then cut my fenders and install the OEM vents. If you don't want to go this route, these vents will get you a decent look (note that in sun light it will be obvious that these are not actual vents and just stick ons).
Julie
Reviewed in the United States on September 21, 2022
This gives my jeep that extra added touch it needed
Recommended Products
$25.98
$ 11 .99 $11.99