Your cart is empty.
Your cart is empty.Product Description
BAB
Reviewed in the United States on November 26, 2023
I love the way these look on my Strat. The only issue is that they are not deep enough to cover all single coils. It does not affect my guitar because you cannot see what's underneath the pickguard, but the pickups are a little more exposed because these do not fully cover my Fender single coils. I have not noticed any difference in tone, which is very important to me. I was a little concerned it might mute the tone, but this hasn't been the case for me. Would I buy these again? Probably. I might try another brand just to see if it would fit the depth better.
Brad
Reviewed in the United States on May 25, 2022
They worked for my dinky. Sanded them a little to try to match the 81. They have nothing inside them and they sit flush with the top of the body. I had to use foam to lift them a little but that's because of what I'm doing with them.
Thomas S.
Reviewed in the United States on May 3, 2021
Went on good, fit tight dont move around and i cant tell any loss.
AcidicExistence
Reviewed in the United States on November 11, 2021
they cover your pickups and they look great. be aware, if you have pole pieces that stick up out of the pickups, if you tighten these down too hard the pole pieces will deform the nice flat surface, permanently.so either use them with flat-top pickups or just don't tighten them too much, or use some form of spacers between the cover and the pickup so they don't crush down over it.
Ron White
Reviewed in the United States on May 25, 2020
Ran across these by circumstance. Just what I needed for the guitar project I am working on.
Sakha
Reviewed in the United States on May 15, 2020
Bought this to put on my seynmour duncan ssl-1 and ssl-5 pickups on a project guitar.I struggles to get them to screw into the pickups, a little too tight but after some work it did fit.I recorded a demo of an after and it made the pickups sounds like plastic, removing them now because getting the pickups in the first place was to get rid of the old plastic tone the original ones had.They look really really cool though, but make sure to measure your pickups first.
Jeff
Reviewed in the United States on December 19, 2019
Mounting distance is correct.Not tall enough on the inside to work with most USA stuff with staggered poles.Leaves a huge gap between the pickup cover and the bobbin base. You could put a spring or piece of rubber tube to compensate, but then your pickups would actually be very far from the strings.
Jeff H
Reviewed in the United States on December 12, 2019
I bought these because the cover to one of my Ultrasonic stacked humbuckers broke (I’m hard on a guitar). This was an adequate replacement, although it was not as tall as the original cover. Still works fine. I’d buy them again.
Recommended Products
$29.99
$ 13 .99 $13.99