Your cart is empty.
Your cart is empty.Brand new magnetic starter for up to 7.5 HP single phase 220-240 volt with steel housing and Heavy-Duty Contactor. Best quality starter with built-in overload adjustable from 30-40 amps. Manual reset button that can be switched to auto reset. Steel housing with four 3/4"punch out holes for incoming and outgoing wires. Includes three rubber grommets for the 3/4" holes to protect connecting wires.
David MacAvoy
Reviewed in the United States on January 25, 2025
I have everything hooked up correctly and my motor will not start on my air compressor. There is no way to contact anyone for customer service. I would not recommend.
Chip
Reviewed in the United States on August 6, 2024
Did not arrive with any wiring instructions and seller website was no help. If you’re an electrician with industrial controls experience, this unit is well made and lower price than its competitors.
big-boss
Reviewed in the United States on July 5, 2024
Nice product. great value good wire point labeling...
BioTools 2020
Reviewed in the United States on July 12, 2024
We bought it for our 5hp compressor. The quality of the item has surprised our technician. For this price, it's a nice deal.
Jenks
Reviewed in the United States on November 6, 2024
easy install bolt write-up, on my Campbell & hausfeld 80gal.compressor
Sawmill Man
Reviewed in the United States on August 1, 2023
The good: I was looking for a product that would turn on a submersible pump that needed to be activated by a remote float switch. This product worked exactly as it was supposed to. Be aware that the box is small and of thin material and if you have larger size wires, it is not big enough to bend them inside to fit. It is also not waterproof, so it will not work outdoors.The Bad: It does require some prior electrical experience as the instructions are not clearly written. In fact if you don't already know how to install a controller, they are no help at all. If the instructions were better written I would have given it 5 stars
Customer
Reviewed in the United States on May 24, 2022
The directions were a little hard to read but I got it done
Ernie Maroon
Reviewed in the United States on May 30, 2020
I purchased his product because of the price and availability. I replaced the one on my compressor that would have cost me four times as much or more. The instructions were not great but if you have some experience with controls you can get it hooked up. The screws in the enclosure were loose and the switch was floating around inside. After inspecting I hooked it up and it worked great. I would definitely recommend this product. I am ordering another for my other compressor.
Recommended Products