Your cart is empty.
Your cart is empty.For 30 years, Mile Marker has been designing and manufacturing drivetrain components that were built for abuse. From lock out hubs, to conversion kits and transfer case accessories, these products and accessories are reliable options for extreme traction.
Bruce H.
Reviewed in the United States on April 23, 2024
I ordered same one I’ve ordered last 3 times. For what ever reason I was sent one that had a 6 hole mount not a 5Luckily I found the one I bought last time and returned the mistakesI use nothing but mile marker thus I DO like themJust a snafu this time 8(
Richard Taylor
Reviewed in the United States on August 30, 2023
I used these on my cj5 build and now have my 4WD back. Also it was a very good price for quality parts.
Victor
Reviewed in the United States on July 18, 2019
Is the perfect size for my international scout
USA1
Reviewed in the United States on September 19, 2018
I decided against using the included locking tabs and got new grade 8 bolts and lock washers. I made sure to read all the literature and I applied a liberal amount of red grease on the inside of these hubs. They come pre-loaded with some grease but a little more is recommended. I also used a new 1" snap ring on the end of the axle. Funny thing, two bolts on each side seemed offset enough where the thin wall socket I was using didn't want to slide over the new bolts. I managed to use a 9/16 open end wrench with success. They work great and look very nice. These are a regular maintenance item, so take them off to clean and relube them along with your wheel bearings! I chose these because they are a domestic USA made product for my AMC Jeep, and the price was great!
stingray13485
Reviewed in the United States on June 14, 2018
Well, cheapest hubs I could find. I wouldn't buy them again. Had a heck of a time getting the snap rings back on, it was almost as if the hubs were to long. The cheap paper gaskets didn't fit the flange on the hubs (ID to small) so I used "Form A Gasket". I also hate the locking tabs supplied. If this is an off road rig that will see some abuse, buy something else. Don't be cheap like I was. I have not tested these yet so to be fair I haven't had any real world experience with them. I'm more annoyed with the install.
Joseph C.
Reviewed in the United States on May 13, 2017
works well but I could not get socket wrench around all bolts to tighten them t
P. Brown
Reviewed in the United States on July 19, 2016
Great replacement hubs for your Dana 30 on a Jeep CJ-7. Easy install if you have snap ring pliers.
Claude
Reviewed in the United States on March 13, 2015
Nice hub, center is not gold but chrome, looks better than picture.
Recommended Products