Your cart is empty.
Your cart is empty.Cody Ross
Reviewed in the United States on June 20, 2024
Didnt take long to scrape old gasket off and install this, thicker and has held up great a year in so far
Mark Coloney
Reviewed in the United States on September 26, 2023
I know it will work just fine!
Luke
Reviewed in the United States on August 13, 2023
Fits well very thick
troy bradley
Reviewed in the United States on June 28, 2023
If your skilled with an xacto knife and your patient they will work, use a new blade on each light and take your time
M. Courchesne
Reviewed in the United States on June 11, 2023
It’s a great replacement gasket set for our 2010 Chevy Silverado 2500HD. Required some light trimming to match the shape of the lamp bottom but does the trick!
Customer
Reviewed in the United States on May 3, 2023
The right shape but a little large. Worked fine. I trimmed the width the large one.
Mike Nebgen
Reviewed in the United States on March 14, 2023
First of all, this gasket doesn't match the size and shape of the light. It's bigger, so it sticks out all the way around the light and doesn't have the same nice factory look. It would be extremely hard to trim it neatly. Also, it's only sticky on one side. The originals stick to both the roof and the light as to really seal it tight. If you're going to try to reuse your lights, I would just use some sort of RTV adhesive. But most likely, your existing lights are broken/cracked if you are looking for this solution. If that's the case, you must replace the whole light. Water gets in thru the cracked or separated edges of the housing and then goes down the clip holes into your cab. Finally, I found the included alcohol lens wipes to be ridiculous and insulting. The factory seals require rubber eraser wheel on a drill to get clean. Those little wipes aren't going to help you with anything.
Don P
Reviewed in the United States on November 28, 2023
Took me about an hour to do one light on my 2013 dually. Had to trim the pad in several places to ensure that the anchors caught properly. The alcohol pads included are a joke. Make sure you clean the old seal off really well so you get a good seal. I would not recommend these.
Recommended Products
