Your cart is empty.
Your cart is empty.Product Description
519-CCB2282L
About NICHE
NICHE specializes in the highest quality Powersports replacement parts. Our parts meet or exceed the quality of the original parts that come with your machine. Some of the NICHE product categories include cylinders, brake pads, axles, off-road mirrors, and drive chains. Let NICHE components fix your machine today!
NICHE Speedometer Cable 519-CCB2282L
Cable Type: Speedometer Cable
- Includes: Speedometer Cable
- Compatible with the following brands: Honda
- Compatible with the following models: CBR1000F,CX500C,GL1000, XR250R,XR500R,XR650L
- Replaces for the following OEM MPN's: 02-0280,44830-GC8-000, 44830-MB7-611,44830-371-010,44830-MG7-000,44830-GE0-710,44830-MS2-000
Cable Comparison
Clutch Cable
What is it?
- A clutch cable allows the vehicle to change gear
Why Replace?
- They break, the constant stress of the cable sliding in and out causes a break at one of the end.
- The cable casing gets damaged due to being close to moving parts, damaged housing causes the cable to bend and corrode.
When to replace?
- A common sign that your clutch cable is damaged and needs replacing is if the clutch lever is stiff or your gear shifts aren’t smooth
Throttle Cable
What is it?
- The engine of your bike needs air and fuel to run. When you turn the throttle, it connects to the pull cable and pulls open the butterfly valve. This allows air to enter the intake manifold
Choke Cable
What is it?
- A choke cable is designed to restrict the flow of air in the carburettor of an engine
Choke Facts
- There is no harm using the choke to start an engine. When it’s cold, it can be a necessity to get started
- Using it a choke will only lead to increase fuel usage, but no damage to the vehicle.
Pull Throttle Cable
What is it?
- This is the cable that pulls open the valve when you turn the throttle. It allows air to get into your engine
When to replace?
- You should replace your throttle cables after three years or 10,000 miles
- If a cable breaks, frays, or you change your handlebar you will need a different cable as well
Push Pull Throttle Cable
What is it?
- A dual cable throttle operation where the pull cable opens the throttle plates, while the push cable, along with a throttle return spring, closes the throttle plates
Installing Tip
- When installing a new cable, make sure to note the routing of the original cable. Also, the dimensions of the new cables must be identical, allowing for the fact that old cables do stretch over time.
Maintenance
- After a race or as often as possible after washing to remove the cables from the bike and flush them through with a blast of air. Also the nipples can also be lubricated, with copper grease
Push Throttle Cable
What is it?
- The push cable is a safety addition, there is a spring that will close the valve whenever the throttle isn’t activated but if the spring fails the push cable safely closes the valve.
When to replace?
- You should replace your throttle cables after three years or 10,000 miles
- If a cable breaks, frays, or you change your handlebar you will need a different cable as well
Cheri
Reviewed in the United States on September 20, 2024
Fits a 1984 xr250r
PG
Reviewed in the United States on July 7, 2024
It's a cheap cable. It works fine on my xr650L but the sheath did separate from the boot and I had to try to recrimp it in place for it to work properly.
Jesse
Reviewed in the United States on April 25, 2024
its a cable and it worked. thanks
Michael
Reviewed in the United States on August 18, 2023
Got another "compatible" cable from a different vendor that was short....... this one was perfect and snapped right it. So useful to know how fast I am going!
david
Reviewed in the United States on March 20, 2023
Works great for 1981 honda xr250r Same as oem
kyle beard
Reviewed in the United States on November 1, 2022
Good quality and fit
Recommended Products