Your cart is empty.
Your cart is empty.Permatex 1 Minute General Purpose Epoxy is a versatile, easy-to-use, general purpose epoxy two-part adhesive and filler system. This clear epoxy sets in 1 minute with no clamping needed. Fills gaps and will not shrink. Resistant to water and solvents. Temperature range -60°F to 180°F (-51°C to 82°C). Permanent strength up to 2500 PSI. Ideal for use on complex, multi-piece assemblies and for bonding rigid materials including ceramic, chrome, fabric, fiberglass, glass, hard plastic, metal and rubber.
Jassy
Reviewed in the United States on March 1, 2025
In spite of what the web page says, this is not grey epoxy. As the package says, it "dries clear". It does set VERY fast; I spent too much time mixing, expecting the cloudiness to clear. It does not; as soon as the faint blue cast goes away, it is ready to use. I actually would give this three stars, but I look only at the 1 stars: I would like people to see this.
dustin choate
Reviewed in the United States on January 28, 2024
This is the best minute epoxy I have used. A word of caution: once the mix turns white, stop stirring and get it on whatever you are gluing. If you keep stirring, you will have 20 second epoxy. Devcon's syringe cap design is the best among its peers. Don't forget to remove the little black stir stick between the syringe plungers before you begin.
Chris K
Reviewed in the United States on November 11, 2023
I was looking for a kind of fast curing Epoxy and found this, however, it took more than 1 hour to cure enough to hold. 1 minute? I doubt it’s claim. One thing, bonding strength should be fine so far.
amco
Reviewed in the United States on December 31, 2020
Also must TOTALLY agree with h.louie, it mixes nicely and immediately sets to the point of non- spreadable, within less than 10 secs. 15 seconds after that, you are not pulling the mixing stick out. So it is almost impossible use: I needed to spread it around a 4¨tube border but it became a boiling hot thick jelly in 10 secs when I had just started. The stated ¨working time¨ of 1 Minute on the packet is TOTALLY wrong, so I wasted my money!
RSFROMTX
Reviewed in the United States on August 3, 2018
Not strong enough. Try gorilla instead
Jared
Reviewed in the United States on September 17, 2016
This worked great for reattaching the rear view mirror on my Subaru. I unsuccessfully tried loctite and permatex rear view mirror adhesives before this. Save your time and money and try this first.
Doc
Reviewed in the United States on October 9, 2014
glues my fingers together really well.
Wilhelm
Reviewed in the United States on February 10, 2012
I bought this for my shop which works with aircraft and have had great results with it and look forward to using it for a long time to come. Whenever we need a good general adhesive that doesnt have to be manufacture spacific or a certain mil-spec we use this. also check out the 5 min stuff for other jobs that require more time.p.s. The 60 sec cure is no joke!!
Recommended Products
$25.35
$ 10 .99 $10.99