Your cart is empty.
Your cart is empty.Posi Lock 210 Manual Puller, 2 Jaws, 14 tons Capacity, 9-2/3" Reach, 1" - 15" Spread Range, 20-2/5" Overall Length
Clint Johnson
Reviewed in the United States on April 22, 2024
These are the best puller in the game. A little pricey but if you are a mechanic or tradesman, you will get your money out of it. I’ve purchased many sizes and when they fail, which has happened to me, it’s operator error.
Dale H
Reviewed in the United States on February 1, 2021
It performs well and it can take a beating.
Lindy K.
Reviewed in the United States on January 16, 2020
Its a Posi lock, made in the US and heavy duty. Not your china /Taiwan junk
Mike, the mechanic
Reviewed in the United States on August 18, 2015
Worked great. Didn't slip off. Was recommended to use to pull JD stalk snapping rolls, off of JD corn head, on John Deere combine.
Lowell C.
Reviewed in the United States on August 3, 2014
Highest quality puller made. It is made to grab on and hold the bearing while you tighten the push screw.
S. W.
Reviewed in the United States on November 8, 2014
Good tool
Rue1960
Reviewed in the United States on November 11, 2014
The puller worked well for removing large bearings.The only issue with the single hinged jaws (pulling arms) on this puller is the shaft diameter can become an issue at full arm extension.The locking is great.
Chip
Reviewed in the United States on October 1, 2014
Fast service. Good quality.
Recommended Products