Your cart is empty.
Your cart is empty.This essential tool for swapping LS Cams slides through factory block holes to keep lifters in place and prevents them from falling All the way through the Lifter bore and into the block. Proper outside diameter and rounded ends prevent damage.
Reid E
Reviewed in the United States on November 16, 2024
Simple tool, works great!
Customer
Reviewed in the United States on October 20, 2023
Don't forget the handle
danny
Reviewed in the United States on September 15, 2022
Fits and holds very well, little pricey.
Nick
Reviewed in the United States on December 16, 2021
Once installed felt loose so I wasn’t sure if it was holding the lifters but I swapped the cam and didn’t have any issues. Did the job!
Customer
Reviewed in the United States on January 14, 2021
Bought these to replace the cam in a 2011 Silverado 5.3. Passenger side went right in. Driver side would not. Dowel was too thick and would not go in. I ended up buying a straight piece of brake line a little bit thinner and works much better and much cheaper. Not worth the money.
J. De Jesus
Reviewed in the United States on April 25, 2021
I literally tried using quarter inch extensions before these came in because I was in patient but I was at work so well and these worked perfectly
Gregory Wright
Reviewed in the United States on February 29, 2020
Good tool for replacing camshaft on ls engine saves slot of time and worry
Rohan Gardener
Reviewed in the United States on January 30, 2020
A little pricey for a tool you won't use much but it sure beats the wood dowel method.
Recommended Products