Your cart is empty.
Your cart is empty.Crankshaft Turning Tool, Balancer Mounted, 1/2 in Drive, Stainless, Natural, Chevy / Ford, Each
Bob Jakupcak
Reviewed in the United States on February 15, 2025
Does exactly what it is supposed to do. I would definitely use a 1" socket on it rather than just sticking it on a 1/2" extension or breaker bar. The center hex is much stronger when gripped from the outside w/ a socket.
Patrick
Reviewed in the United States on August 18, 2024
This worked perfectly. I read reviews before using it and the repeated comments to use a socket on the tool if breaking an engine loose were very helpful. I had a stuck ford 351m engine and it would not budge with all the strength I could put into it with a 3 foot breaker bar. The tool held up to a cheater pipe over a breaker bar and about 5 feet of leverage and did exactly what I needed it to do. 😁
Haley
Reviewed in the United States on July 17, 2024
Bolted right up.. I used a 1 inch on it not the half inch drive as I didnt wanna crack it because I'd be doing some serious wrenchin... it took a 4 foot cheater on the breaker bar to get the motor moving... its now running today.
Keysha
Reviewed in the United States on December 24, 2024
Comes in handy
Dale
Reviewed in the United States on November 12, 2024
Metal construction was heavier than expected
Hmclean
Reviewed in the United States on August 7, 2023
Purchased for a mid 70s 350 SBC that was seized from sitting. Removed the crank bolt and three bolts holding the pully to the Balancer. Installed this tool. Used a 1" 6 point socket. was able to break loose the stuck engine (after soaking with MMO and PB Blaster for a week). Tool worked great and saved from stripping or breaking the crank bolt.
Placeholder
Reviewed in the United States on June 19, 2023
I used this tool with a 1" impact socket, a breaker bar and a 4' pipe off my floor jack.I added Pb blaster to all the cyls and let set a week. Then removed all the plugs and broke the stuck engine free. rocking back and forth at first, then the 5 full rotations, rocking here and there. After that i could rotate the engine with just the breaker bar alone.Also i loosened all the belts as they had rusted into the pulleys. This engine sat for 8 years in a boat wo a cover and filling with snow and this tool worked great. don't use just the breaker bar, you can crack the tool, always use with the 1" impact socket - it was only 5$ from lowes.
DTrain
Reviewed in the United States on December 3, 2023
Broke on the very first use. I was not using an impact driver on it. In fact, it had a static load on it when it cracked. Garbage.
Recommended Products
$35.67
$ 18 .99 $18.99
$90.28
$ 36 .99 $36.99