Your cart is empty.
Your cart is empty.Polyurethane based suspension, driveline and chassis components have been designed as an upgrade to the soft factory rubber components.
Sheminator
Reviewed in the United States on April 29, 2022
Bought for my 1970 Buick Skylark. So much better than the factory rubber bushings. Firms up the front end beautifully. Installed very well, though removing the old bushings and shells was a major operation. Do your research and prepare before you start.
Vincent
Reviewed in the United States on December 28, 2021
Poor description of what vehicles this kit will actually fit.
Thomas G.
Reviewed in the United States on June 11, 2020
Perfect fit for my 72 nova, drives like a totally different car.
Jim in Washington State
Reviewed in the United States on March 10, 2015
Perfect fit for Chevelle,NOTE: this is a set of bushings, that should be dissasembled for installation, slide the inner sleeve out, slide out the bushing, press the outer sleeve into the control arm, grease the bushing LIBERALLY (buy some Prothane grease extra, you will want it / need it - it's designed for Urethane/Steel lubrication), then install the inner(bolt) sleeve(s), this will give you no fits, and a squeak free installation. Theses bushings are designed to become a rotating part of your suspension, not a "twisting piece of rubber" like the factory bushings.Substantial improvement in road feel and cornering flatness. HUGE gain in performance taking my favorite on ramp (read local road course!!)So good, had to do the rears, sway bar bushings, etc. Massive improvement, - High quality, made in U.S.A. !!Thank you for such a great product.
Recommended Products