Shopping Cart

Your cart is empty.

Your cart is empty.

QD 1.25 Inch Swivels Mount Quick Detach Loop Base Kit with 4 Screws + 1 nut + 1 Wrench

Free shipping on orders over $29.99

$13.99

$ 6 .99 $6.99

In Stock
  • Push button QD swivel with 1.25” loop.
  • Mount Base Kit – With 4 screws + 1 nut + 1 wrench.
  • Constructed of black phosphatized steel.
  • High Strength Steel (can withstand 250 pounds of tension).
  • Easy to install and remove with top push button design.


Feature:

Push Button QD Swivel, 1.25” Loop, Through salt spray test.

Manganese phosphate surface treatment.

Easy to install and remove with top push button design

Mount Base Kit – With 4 screws + 1 nut + 1 wrench,

black phosphatized steel construction easily installs with provided hardware.


Package included:

1x Quick Detachable Swivel

1x Mount Base

4x Steel screws

1x stainless steel nut

1X wrench


Phil A.
Reviewed in the United States on July 19, 2024
If you are getting these for the backpacker stock, you will need a #8 washer for the front. These are slightly too short to work correctly without it. Other than that they are great quality.
Paul
Reviewed in the United States on December 9, 2024
I rarely leave reviews but in this case I had to. After reading other reviews here stating that these fit Magpul stocks, I decided to try a save a few bucks over the Magpul QD's. I have a Magpul Backpacker stock and an SGA butstock. I had to shim the QD cups to sit flush with the surface of the stock so the sling swivels would insert into the cup deep enough to engage the ball bearings. In other words the cups are too short for the depth of The Magpul cup holes. If you don't mind shimming the cups then its no big deal. Happy Trails.
Marcus carr
Reviewed in the United States on November 8, 2024
great little system came in handy
Mr. Kay
Reviewed in the United States on November 24, 2024
Good workmanship. Nice finish and easy to install. The silver nut should be replaced with a black acorn nut but that's just my preference. In which I did.
Customer
Reviewed in the United States on November 14, 2024
To bolt on my hunting rifle. Tight, very little play. Female piece accepts my service sling's QD male button tightly.
Adam
Reviewed in the United States on November 1, 2024
Overall, this was great. Would definitely recommend !!
Disturbedsol
Reviewed in the United States on October 29, 2023
Has to use a couple of washers to push it out of the stock far enough to get the qd to engage. Magpul hunter x22 stock
Mike M
Reviewed in the United States on January 1, 2021
Magpul sold these sling mounts for about $60 a pair. I saw these and decided to give them a try. They were much less expensive. They worked great. The product is make well, strong, and looks as good as the ones at magpul. They fit the recessed holes perfect. I did end up using a couple of small metal washers just to bring the nut a little further out. It was not necessary to make it work. I just felt it looked better and worked better with the screw length. They work great.
Recommended Products