Your cart is empty.
Your cart is empty.Michelle E. Ottosen
Reviewed in the United States on February 8, 2025
Worked as promised. Love that this clock automatically sets the correct time using radio frequency. Easy to set up following directions.
Customer
Reviewed in the United States on February 24, 2025
Does everything as described.Battery goes dead after a week and a half. Warning. Makes it almost worthless and cannot recommend.
phil
Reviewed in Canada on September 29, 2024
Very inpressed. Good product!
A Guy
Reviewed in Canada on July 15, 2024
Upgraded our wall clock to atomic like another we have. Super easy to do and even has a daylight savings time switch on the back. Very impressed. Very happy. Would buy again.
William J. Sikkens
Reviewed in the United States on February 13, 2024
These movements are badly, cheaply made units. I ordered 2. They both ran for a very short time and quit. They were installed correctly and another movement worked fine. Pay a little more and get a better movement if you want your clock to work. Use this one only if you want a paperweight.
Customer
Reviewed in the United States on December 14, 2024
After understanding instructions installed clock mechanism and clock works great.
Zenos
Reviewed in Canada on November 8, 2024
Bought 2, within 15 minutes one synced perfectly. The other synced 40 minutes fast but synced appropriately overnight.Only downside is the arms that come with it only work for clocks
Mike A.
Reviewed in the United States on November 10, 2024
I purchased this as a replacement movement for a radio controlled wall clock that was several years old and the original movement quit working.I installed the movement in the clock and put on the hands, all at the 12:00 position per the instructions. I pulled out the pin that holds the hands steady and put the movement and face back in the clock, only to find out that the movement stuck out farther from the clock face than the old movement did, and the second hand was hitting the inside of the glass face of the clock!I had to remove the hands and put some spacers between the movement and the clock. When I went to put the hands back on the movement, without the pin in the movement any longer, the shafts which hold the hands rotated and it took me several tries to make sure the hands lined up at the 12:00 position. Moral of the story - check the fitment into the clock first, after installing the movement and hands, but BEFORE you pull out the pin from the movement! That way, if you have to remove and reinstall the hands it will be a snap to get them properly lined up, as long as it is done before the pin is pulled. Once the pin preventing the hands moving is pulled out from the back of the movement, it's not easy to put the hands back on in the right place. Overall it installed easily enough, there was a ridge on the hour hand shaft that was preventing the hour hand from being installed, a few quick scrapes with a pocket knife on the hour hand shaft fixed that.The movement runs well and has kept itself set properly, it went right to the exact time about 10 minutes after installing the battery. Would have given 5 stars if not for having to shave the ridge off the hour hand, but that overall was a minor deal. The hour hand just would not go on no matter how hard I pushed it, until that ridge was removed, then it installed easily.
Customer
Reviewed in the United States on September 7, 2023
Bought this to replace an older radio clock mechanism that gave up after several years. It almost fit right in, I did have to trim a few plastic tabs in back so the mechanism body would go flush against the back, and shorten the hands a bit with snips so they would fit inside the clock face. At any rate it all works and has kept perfect time for a few weeks so far. This was somewhat cheaper than replacing the whole thing. No issues.
Irish
Reviewed in the United States on September 30, 2023
This time movement is worthless. It never connected to the atomic clock as they call it . I have had it since September of 2023 and it still does not have the correct time I have reset it a number of times and it always ends up wrong. don't waste your money on it
Jamison
Reviewed in the United States on August 28, 2023
First clock movement I ordered didn’t work right. Kept time off by a half hour and would change itself even after I fixed the time. I wrote a review on that experience. Without even reaching out myself, the seller reached out and offered to replace the defective movement. I received it today and it is working great. Satisfied customer and I’d order again.
RUSSELL S.
Reviewed in Canada on March 14, 2023
The missing step is to check in the back if the slider switch is set to the right timezone: P(acific), M(ountain), C(entral), or E(astern), and confirm DST (usually "ON"). Those living in Atlantic or Newfoundland timezones I guess have to set the clock manually. As others have pointed out, patience is key, it can need overnight to calibrate.
Alex
Reviewed in Canada on July 24, 2022
Works in Vancouver, BC.
Recommended Products